2 Site Plan

SITE PLAN
PROJECT:
SMART RESIDENTIAL
BIMODAL SYSYEM
TOP VIEW
PROPERTY OF:
POWER SYSTEM
EVOLUTION
ADDRESS:
C1 H9 HILLSIDE SAN
JUAN, P.R.
LOT
NEIGHBOR
SHEET TITLE:
LOCATION:
PREPA ACCOUNT #
C1 H9 URB. HILLSIDE, SAN JUAN, P.R.
6031032406
HOME OWNER:
PREPA METER #
CAMACHO ORTIZ, JOAQUIN
00002883323
51.5'
SITE PLAN
SCALE:
NOT SCALE
DRAWING BY:
EDWIN REYES MACHADO

DATE:
SEPTEMBER 29, 2015

PROJECT NO:
COORDINATES:
SHEET NO:
2-9
32.5'
DRAWING NO:
3.0'
E-1
24.0'
URB.HILLSIDE
CALLE 1
SAN JUAN, P.R.
32.5'
LEGEND:
Important notes
TRINA SOLAR TSM-PA05 250W, (29) MODULES IN 3 ARRAYS. ONE ARRAY OF 9 MODULE
AND 2 WITH 10 MODULE EACH ONE, FOR A TOTAL CAPACITY OF 7.25KW DC.. RACKING,
SNAP AND RACK SYSTEM. ARRAY TILT, BETWEEN 15 DEGREE EACH ARRAY.
3.0'
WIND TURBINE, TOTAL CAPACITY OF 1KW, 48 VOLTS.
5.5'
EXISTING ELECTRICAL PANEL, INDOOR LOCATION.
29.25'
5.5'
EXISTING PREPRA METER WITH MAIN BREAKER, INDOOR LOCATION.
PREPA BIMODAL SYSTEM DISCONNET UNIT, 60AMP.
34.4'
M
EXISTING
ELECTRICAL
PANEL
(INDOOR)
TREE
5.5'
15.0'
SOLAR SYSTEM
TSM-PA05 250W
29 MODULES OF 250 W
TOTAL POWER 7.25 kW
11.6'
DESIGNER'S CERTIFICATION
PREPA
METER WITH
MAIN
BREAKER
(INDOOR)
1. I certify that I am a licensed engineer or archited member of the collage of my profession and
authorized by this project's owner to present these construction plans to PREPA.
2. In compliance with Law No. 7 of July 19, 1985, as amended, known as
Certification Law, I certify that I prepared the electric design of this project following all codes,
standards, norms and regulation approved by PREPA. Puerto Rico Planning Board and Permits and
Regulation.
21.0'
DATE:
__________________
__________ ___________________________
LIC. NO: __________________
DESIGNER'S SIGNATURE
__________________________________________________________________________________
WIND SYSTEM
TOTAL POWER 1.0 kW
35.0'
PREPA BIMODAL
SYSTEM
DISCONNECT UNIT
(OUTDOOR)
PUERTO RICO ELECTRIC POWER AUTHORITY

ENDORSEMENT
PROJECT NAME: SMART RESIDENTIAL BIMODAL SYSTEM
PROJECT NUMBER: _________________________
DESIGN KW: ____8.25 KW_______
ENDORSED BY: ____________________________
DATE: _______________________
1. PREPA endorses the electric design shown in these construction plans based on the certification
presented by the designer in compliance with Law No. 7 of July 19, 1985 as emended.
2. PREPA does not assume responsibility over the certified design. PREPA's endorsement does not
relieve the designer from the professional responsibility assumed with the certification on these
project's plans. This endorsement receives neither the builder nor private inspector from compliance
with standing dispositions from National Electric Code; National Electric Safety Code, construction
standards, norms and regulation from PREPA and other government agencies as well as federal and
state laws ruling by the time construction begin.
LOT
NEIGHBOR
3. This endorsement is valid for one year. If electrical works have begun during this year, with prior
notification to PREPA, the endorsement will still be valid until work's completion. In case there is not
certified electrical work during a twelve month period, this endorsement will lose its validity.
__________________________________________________________________________________
OBSERVATIONS
1) RELOCATION OF EXISTING LINES AND WORK IN CONNECTION WITH ENERGIZED LINES
WILL BE DONE BY PREPA WITH THE SOLICITOR PAYING THE COST AS INCURRED WITH
PREVIOUS NOTIFICATION BY THE BUILDER, THE ABOVE MENTIONED WORK SHOULD BE
COMPLETED BEFORE COMMENCING THE WORK OF CONSTRUCTIONG THE PROJECT.
2) THE APPROVAL OF THESE PLANS BY THE AUTHORITY DOES NOT RELIVE THE BUILDER
OF COMPLYING WITH EACH AND ALL OF THE REQUISITES ESTABLISHED BY THE NATIONL
ELECTRIC CODE AND THE REGULATION OF THE PUERTO RICO ELECTRIC AUTHORITY.
3) THE APPROBAL OF THESE PLANS IS ON THE CONDITION THAT THE AUTHORITY BE
CONSULTED ON THE CONDITION OF THE ELECTRICAL SERVICE AT THE TIME OF
BEGINNING CONSTRUCTION.
1. The contractor must verify all

dimensions and site conditions
before proceeding with work. If you
find any error, omission or failure,
the contractor shall notify the
Engineer before and / or continue
the work until corrections are made.
The engineer must be notified about
the error, omission or failure and
continuous work the contractor shall
be responsible for any errors,
omissions and / or omissions.
2. All designs and drawings and
prints content issued by "power
system evolution" are the exclusive
property
of
"power
system
evolution" and should not be reused
elsewhere. Except for which they
were specifically designed.
3. Information and documents
presented here are the property of
"power
system
evolution",
reproduction or use part or all of
this document and the information
may be performed by authorized
persons must submit a written
consent of "power system evolution
"might otherwise be in violation of
copyright which is completely
forbidden.
4. The Contractor shall not use
any drawing or design obtained
ahead to begin construction. All the
designs or patterns used by the
contracted must be stamped tags for
construction only and it must be
signed by a professional engineer.

2 Site Plan

Uploaded by

Copyright:

Available Formats

2 Site Plan

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

2 Site Plan

Uploaded by

Copyright:

Available Formats

SITE PLAN

C1 H9 URB. HILLSIDE, SAN JUAN, P.R.

CAMACHO ORTIZ, JOAQUIN

EDWIN REYES MACHADO

SEPTEMBER 29, 2015

WIND TURBINE, TOTAL CAPACITY OF 1KW, 48 VOLTS.

EXISTING ELECTRICAL PANEL, INDOOR LOCATION.

EXISTING PREPRA METER WITH MAIN BREAKER, INDOOR LOCATION.

PREPA BIMODAL SYSTEM DISCONNET UNIT, 60AMP.

PUERTO RICO ELECTRIC POWER AUTHORITY

DESIGN KW: 8.25 KW___

ENDORSED BY: ____________________________

1. The contractor must verify all

You might also like