Scribd
Upload
38 views

Text Panel User Guide

The document provides a user guide for a text panel that controls a machine. It describes the following: 1) The first page displays date, time, operating mode (manual, semi-auto, auto), time delay between cycles, total cycle count, and time for a single cycle. 2) The second page shows sensor statuses and current operating mode. 3) Additional pages in manual mode allow controlling frame movement, squeegee motor rotation, rubber/coating plate tension checks, zig height, and squeegee position. 4) The fifth page allows bypassing sensors and setting squeegee delay times when in manual mode.

Uploaded by

shanmugam86
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
38 views

Text Panel User Guide

The document provides a user guide for a text panel that controls a machine. It describes the following: 1) The first page displays date, time, operating mode (manual, semi-auto, auto), time delay between cycles, total cycle count, and time for a single cycle. 2) The second page shows sensor statuses and current operating mode. 3) Additional pages in manual mode allow controlling frame movement, squeegee motor rotation, rubber/coating plate tension checks, zig height, and squeegee position. 4) The fifth page allows bypassing sensors and setting squeegee delay times when in manual mode.

Uploaded by

shanmugam86
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 5

TEXT PANEL USER GUIDE

1.FIRST PAGE:

After Power ON the Machine TEXT PANEL Display the above


screen.
It indicates the Date, Time, Current Mode, Time Delay, Total Cycle
Count and Time Duration of single Cycle.
MODE:
We can perform Three kinds of Modes of operation

1.MANUAL MODE:
In this mode Arrow of the selector switch will
be pointing towards Left.
2.SEMI AUTO:
In this mode Arrow of the selector switch will be
pointing towards center then we press the Cycle Start Button.
3.AUTO MODE:
In this mode Arrow of the selector Switch will
be pointing towards Right and once Push button(Cycle Start
Button) is pressed the Cycle will be continuously Running.
DELAY:
It displays the time delay between two cycles of operation.
TIMER:
Here we can set the delay between two cycles of operation by
using F2 key.
COUNTER:
It Shows the Number of cycles completed so far. We can
reset the Counter By pressing F3 Key.
TIME DURATION OF SINGLE CYCLE:
It shows the time duration of single cycle.

2.SECOND PAGE

It shows the status of all sensors


Its also show the Current mode of operation
FOURTH PAGE:

this page will come only in manual mode

FR.DOWN
-- FR.UP
--
SQ.RIGHT

By pressing F1 key FRAME Will go Down


By Pressing F2 key Frame Will go Up
--- By pressing F3 Key squeezing motor rotate
In Clockwise direction.
SQ.LEFT
--- By pressing F4 key Squeezing motor
rotate In
Anticlockwise direction
M.SQ.ACTION
--- Manually we can check the Squeezing
Rubber
Tension by pressing F5 Key.
M.FLOOD.ACTION -- Manually We Can check the Coating
plate tension by pressing F6 Key.
RIGHT LEVEL
--- It will rise the ZIG upwards by
pressing F7 Key.
MANUAL MIDDLE MOVE ---- We can move the squeezing
motor to the middle position.

FIFTH PAGE:

This page will come only in manual mode


we can ON/OFF the P-OFF BYPASS using F1 key.

We can set the Middle squeegee delay by using F2 key.

You might also like