Scribd
Upload
134 views15 pages

Electronic System Reliability Engineering PPT-c09

Electronic system Reliability Engineering PPT

Uploaded by

krish
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
134 views15 pages

Electronic System Reliability Engineering PPT-c09

Electronic system Reliability Engineering PPT

Uploaded by

krish
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 15

Chapter 9

Electronic Systems
Reliability
2012 John Wiley & Sons, Ltd.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.1 Parameter drift.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.2 Temperature vs. reliability for electronic components.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

(a)

(b)

(c)

Figure 9.3 Examples of electronic components. (a)


Leadless chip capacitor (b) Quad flat pack IC package
(QFP) (courtesy DfR Solutions) (c) Ball grid array (BGA) IC
package.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.4 Five stacked die 4GB flash memory (pyramid


stacking with wire bond interconnects). Reproduced by
permission of DfR Solutions.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.5 Micro-hybrid (Courtesy National


Semiconductor Corporation).

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.6 Typical failure density functions of electronic components


when no component burn-in has been carried out.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.7 Logic device protection. Diode D1 prevents the input voltage
from rising above the power supply voltage. Capacitor C1 absorbs high
frequency power supply transients. Reproduced by permission of Reliability
Analysis Center.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.8 Transistor protection. Resistor R1 limits the base current IB


and capacitor C1 absorbs power supply high frequency transients.
Reproduced by permission of Reliability Analysis Center.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.9 Temperaturepower derating


for transistors and diodes (typical).

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.10 Digital circuit noise decoupling.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.11 Sneak analysis basic patterns (hardware).

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.12 Parameter distributions after selection.

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.13 Transpose circuit (from Spence and Soin (1988)).

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

Figure 9.14 Monte Carlo analysis of filter circuit (from


Spence and Soin (1988)).

Practical Reliability Engineering, Fifth Edition. Patrick D. T. OConnor and Andre Kleyner.
2012 John Wiley & Sons, Ltd.

You might also like