TK110 User Manual

User Manual
Version 2.1
1. Accessories
This user manual has been specially designed to guide you through
the functions and features of your GPS vehicle tracker.
Charging cable (Standard)
2. Specification
Dimension
Weight
Operation Temperature
Operation Voltage
Humidity
GSM Frequencies
GPRS
GPS Sensitivity
Acquisition Sensitivity
Position Accuracy
TTFF Open Sky
GSM/GPS Antenna
LED Indicator
Data Transmit
Non-movement Detection
Mileage Report
90(L) x 45(W) x 13.5(H) mm

45g
-30 - 70
9-36vDC
20% - 80%
850/900/1800/1900 MHz
Class 12
-159dBm
-144dBm
10m
Cold Start: 38s
Warm Start: 32s
Hot Start: 2s
Built-in design
GSM-green, GPS-blue, Power-red
TCP, SMS
Movement alarm based on built-in 3D
motion sensor
Track by time/distance interval
3. Quick Operation Instructions

Change APN parameter by sending SMS APN,666666,APN name# and
SERVER,666666,1,www.gptrack.net,8821,0# to the device.

3.1 Locate current position by GPRS/SMS
3.2 GPS tracking platform:
3.3 Track by time interval via GPRS
Send SMS TIMER,666666,,time(second)# to device. 10s in minimum
while 18000s(5 hours) in maximum.
3.4 Change password
The default password is 666666. Send SMS PASSWORD,old password
(6 numbers),new password (6 numbers)# to the device.
3.5 Real-time Location Tracking via SMS
3.5.1 Send SMS WHERE,666666# to the device, you will get the
current location of the device.
3.5.2 Send SMS URL,666666# to the device, you will get the URL of
the current location by maps.google.com.
4. My Device
5.
LED Indications
GPS LED Indicator

Flashing (1s on, 1s off)
Continuously bright
Continuously dark
Searching GPS signal

GPS fix
No GPS fix or initializing
GSM LED Indicator

Quick flashing
Continuously bright
Continuously dark
GSM initializing
Connected to Server Sucessful
No GSM signal
Power Status
Flashing
Continuously bright
Continuously dark
Power on
Not working properly
Power off
6.Method of installation
6.1 Preparation before installation
1)Open the packing box to check whether the type of device is correct
and whether the accessories are included.
2)This product is a high-tech electronic device, installation should be
undertaken by a professional.
3)Please follow the following procedures to install your TK110.During
installation, there should be no power to the device.
6.2 Installing SIM card: each TK110 need to insert a GSM SIM card. The
SIM card used should be enabled for GPRS.
1) Testing SIM card: to test SIM card, please install it into a normal GSM
mobile and ensure it can send and receive SMS, and enables for
GPRS.
2) Installing SIM card:Remove the upper cover of device,insert SIM card
as shown then replace cover,lock the Shell With 3 bolts.
6.3 Selecting installation place and fixing it.There are two

kinds of installation: covert and non covert.
If you need the covert installation, please refer installation to an auto
electrical contractor.
Note:
1) To prevent theft of the TK110,the device should be installed as
covertly as possible.
2) Avoid placing the TK110 close to higher power electrical devices,
such as reversing radar, anti-theft device or other vehicle
communication equipment.
3) The TK110 should be fixed into position with cable ties or wide
double-side tape.
4)Your device has built-in GSM antenna and GPS antenna. During
installation, please make sure the receiving side face is up, with no metal
object above the device to interfere with GPS reception. The following
places are suggested for installation:
- Under the dash board below the front windshield;

- In the parcel shelf in the rear;
- In the front bumper( non-material face), please ensure the device cannot
get wet;
- Under the wiper version (non-metal), please ensure the device cannot
get wet;
Notice: If the windshield is pasted with metal thermal-protective coating,
it may affect the performance of the device. In this case, please change
the installation place after consulting the professional.
5)Non Covert Installation,
Firstly fix the device on the dash board below windshield.
7. Cautions of device wiring

7.1 The standard voltage is 9V-36V, the red wire is the positive, the black
wire is the negative.
7.2 Please connect the black wire to ground.
7.3 After connecting the power cord, run the power cord plug to the
device. After installation, supply power to device.
7.4 Covert installation: car battery cord is standard, with 2A FUSE for
short-circuit over current protection.
7.5 Non covert installation: cigar lighter cord is optional, with 2A FUSE
for short-circuit over current protection. Please contact your dealer if this
mode is needed.
8. Power on/ off
8.1 The device will power on automatically when connected to power.
During normal operation, red power LED flashes, while blue GPS LED
and green GSM LED keep lighting. During signal searching process, GPS
or GSM LED will flash. If there is no light presenting on LEDs, the
device is not working normally.installation, please make sure the
receiving side face is up, with no metal object above the device to
interfere with GPS reception. The following places are suggested for
installation:
8.2 The device will power off after power is disconnected.
9. Side key function
At normal-work indication status, press the side key, all the three LEDs
will extinguish and then the device will enter covert working mode. Press
the key again, the three LEDs will go back to normal-work indication
status.
10. Troubleshooting
10.1 If GPS can not receive the signals normally, please drive to the open
areas for positioning. Generally, it needs 1-2 minutes to receive the first
coordinates. If the data can not be received after 2-3 minutes, please
check the installation position of the device, making sure it is not being
shielded by any metal.
10.2 If GSM can not receive the signals normally, please check whether
SIM card is installed correctly or there is no GSM signal at the current
location , such as a basement parking, please drive to a place covered by
GSM signal.
10.3 If the red LED does not work when power is connected, check
whether the fuse is blown. If so, please replace the fuse.
10.4 If the three LEDs do not turn on when power up, press the down
side key, if the three LEDs recover normally, the device is working
normally.
10.5 If you have enabled the web based tracking application, and the
device displays off-line on the platform, please check 3 LEDs status
indicators first. You can check the status of the SIM card when you are in
an inconvenient situation. Please refer to the following steps:
1)Call the device to check whether you can get through.
2)Check whether the SIM card supports GPRS and a local APN.
3)Check the GSM/GPS reception area.
4)Check whether there is enough credit on the SIM card.
5)Check if the connector and terminal is loose or the fuse has blown out.
11.SMS command
1 Password,old password,new password#
Example:Password,666666,777777#
2 Recover,new password#
Example:recover,777777#
3 Server,password,mode,IP/DNS,port,0#
Change password, default password:666666

Change password from 666666 to 777777
Change password to default password:666666
Change password to 666666
Set server parameter.mode:0,IP mode;
mode:1,DNS Mode.
Example:server,666666,0, 112.124.25.181,7018,0#
Set server IP: 121.13.112.68,server port:8821
Example:server,666666,1,www.gpsbox.net,8821,0#
Set server DNS:www.gpsbox.net,port:8821
Apn,password,apn name,apn user,apn password#
Set APN parameter.If apn user,apn password not

needed, not write
Example:China Mobile SIM card.command:apn,666666,cmnet#
Set APN name:cmnet
Example:Canada FIDO SIM card.command:APN,666666,
Set APN name:internet.fido.ca,apn user:fido,
internet.fido.ca,fido,fido#
apn password:fido
where,password#
GPS data position query
example:where,666666#
The tracker reply:Lat:N23.117475,Lon:E114.

418433,Course:0.00,Speed:0.5204,DateTime:12
-07 -02 21:05:43
URL,password#
Google link query
example:url,666666#
The tracker reply:<DateTime:12 -07 -0221:

05:43>
http://maps.google.com/maps?q=N23.117475,
E114.418433
timer,password,,upload time interval#
Set upload time interval.

5-1800 seconds,the default time interval
is 10 seconds
example:timer,666666,,50#
Set upload time interval 50 seconds.
gmt,password,time zone direction,time zone code#
Set time zone.Time zone direction:E or

W.Time zone code:0-12.
example:gmt,666666,e,2#
Set time zone east 2 time zones.
FACTORY,password#
Change to factory setting.IP,port,DNS

,password can not be changed
factory,666666#
Change to factory setting.IP,port,

DNS,password can not be changed

TK110 User Manual

Uploaded by

Copyright:

Available Formats

TK110 User Manual

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

TK110 User Manual

Uploaded by

Copyright:

Available Formats

What are the main components and specifications of the GPS tracker?

What are the main components and specifications of the GPS tracker?

How do you configure the GPS tracker?

How do you configure the GPS tracker?

User Manual

Charging cable (Standard)

90(L) x 45(W) x 13.5(H) mm

3. Quick Operation Instructions

SERVER,666666,1,www.gptrack.net,8821,0# to the device.

GPS LED Indicator

Searching GPS signal

GSM LED Indicator

6.3 Selecting installation place and fixing it.There are two

- Under the dash board below the front windshield;

7. Cautions of device wiring

Change password, default password:666666

Set server IP: 121.13.112.68,server port:8821

Set server DNS:www.gpsbox.net,port:8821

Apn,password,apn name,apn user,apn password#

Set APN parameter.If apn user,apn password not

Example:China Mobile SIM card.command:apn,666666,cmnet#

Set APN name:cmnet

Example:Canada FIDO SIM card.command:APN,666666,

Set APN name:internet.fido.ca,apn user:fido,

GPS data position query

The tracker reply:Lat:N23.117475,Lon:E114.

Google link query

The tracker reply:<DateTime:12 -07 -0221:

timer,password,,upload time interval#

Set upload time interval.

Set upload time interval 50 seconds.

gmt,password,time zone direction,time zone code#

Set time zone.Time zone direction:E or

Set time zone east 2 time zones.

Change to factory setting.IP,port,DNS

Change to factory setting.IP,port,

You might also like