Scribd
Upload
2K views

Modelling of Transformers in PSSE

Modelling of Transformers in PSSE

Uploaded by

osdds
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views

Modelling of Transformers in PSSE

Modelling of Transformers in PSSE

Uploaded by

osdds
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Modelling of transformers in PSS/E

Figure 1 represents the internal PSS/E model for the two winding transformer model
and Figure 2 resents its approximated transformer model. In this model Z represents the
series impedance and Ym represents the magnetizing admittance [1],[2].

Figure 1: PSS/E Transformer models of two winding transformer model

Figure 2: Standard PSS/E two winding Transformer circuit

Modelling of two winding transformers in PSS/E requires following minimum


parameters. They are,
Winding 1& 2 ratio (pu) = 1pu:1pu ratio was set in the model.

Winding 1&2 Nominal Voltage (kV) = Respective voltages of the buses was entered in the
model.

Winding MVA = 100MVA which is the default power base was set.

Rate A (MVA) = Transformer capacity.

Rate B (MVA) = The contingency rating is set 120% of the Rate A.

Series Resistance R (pu) = assumed to be negligible.

Series Reactance X (pu) = Since the series resistance was assumed to be negligible, reactance
(X) was assumed to be equal to the percentage impedance (Z).

Shunt Conductance G (pu) = Assumed to be negligible.

Shunt Susceptance B (pu) = Assumed to be negligible.

References

[1]

PSSE 33.2 Program Operation Manual. Siemens Industry, Inc. Siemens Power

Technologies International.
[2]

Transformers in the positive sequence, in Program Application Guide, vol. 1, 2 vols.,

SEIMENS.

You might also like