2.3.1.1 WAN Device Modules Instructions - IG
2.3.1.1 WAN Device Modules Instructions - IG
2.3.1.1 WAN Device Modules Instructions - IG
Instructor Note: Red font color or Gray highlights indicate text that appears in the instructor copy only.
Objective
Select WAN access technologies to satisfy business requirements in a small-to-medium-sized business network.
Instructor Note: This activity can be completed individually or in small groups it can then be shared and
discussed with another group of students, with the entire class, or with the instructor.
Scenario
Your medium-sized company is upgrading its network. To make the most of the equipment currently in use, you
decide to purchase WAN modules instead of new equipment.
All branch offices use either Cisco 1900 or 2911 series ISRs. You will be updating these routers in several
locations. Each branch has its own ISP requirements to consider.
To update the devices, focus on the following WAN modules access types:
Ethernet
Broadband
BRI
Serial
Resources
Directions
Step 1: Visit Interfaces and Modules. On this page, you will see many options ISR interface
modules options remember that you currently own and use only the Cisco 1900 and
2900 series routers.
Note: If the above link is no longer valid, search the Cisco site for Interfaces and Modules.
Step 2: Create a comparison matrix listing the following WAN access types for your branch
networks:
Ethernet
Broadband
BRI
Serial WAN
2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 1 of 5
Step 3: In the matrix, record the interface module type you need to purchase for your ISRs for
upgrade purposes.
Step 4: Use the Internet to research pictures of the modules. Provide a screenshot of the
module or a hyperlink to a picture of each module.
Step 5: Share your matrix with a classmate, group, class, or your instructor.
This is a good place to have students discuss the terminology. For instance, WIC2T = WAN Interface Card
with 2 serial ports.
Students can also add various cards to routers in PT and use commands such as show ip interface brief to
view the changes.
Please encourage students to read the datasheet information listed on the modular card graphics sites they
will become familiar with different interface types by doing so.
All graphics will vary as shown in the students final matrix the graphics shown in this Activity Example
Solution are representative in nature and were copied from the Cisco products sites. Each graphic is
hyperlinked to the source available at the time this activity was created.
2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 2 of 5
WAN
Access
Type
Multimode
VDSL2/ADSL/2/2+ EHWIC
Annex (A, B, and M
variations)*
Multimode EFM/ATM
SHDSL EHWIC
Ethernet
Broadband
2-port Channelized
E1/T1/ISDN PRI HWIC*
1-port Channelized
E1/T1/ISDN PRI HWIC
2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 3 of 5
One-port clear-channel
T3/E3 Service Module
1-Port T1/Fractional T1
DSU/CSU High-Speed WAN
Interface Card*
T1/E1
Trunk
Voice and
WAN
Wireless
LANs and
WAN
2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 4 of 5
2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 5 of 5