Scribd
Upload
39 views3 pages

Solar System Model

The document provides instructions for creating a model of the solar system using cardboard, paper, string, and other materials. It describes drawing concentric circles on cardboard to represent the orbits of the planets around the sun, punching holes in the cardboard along each orbit, cutting out circles to represent each celestial body, taping strings to the back of each circle and threading the strings through the correct orbit holes, and finally hanging the completed model from the ceiling. The finished product allows students to visualize the relative sizes and distances of objects in our solar system.

Uploaded by

Mauro Castaño
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
39 views3 pages

Solar System Model

The document provides instructions for creating a model of the solar system using cardboard, paper, string, and other materials. It describes drawing concentric circles on cardboard to represent the orbits of the planets around the sun, punching holes in the cardboard along each orbit, cutting out circles to represent each celestial body, taping strings to the back of each circle and threading the strings through the correct orbit holes, and finally hanging the completed model from the ceiling. The finished product allows students to visualize the relative sizes and distances of objects in our solar system.

Uploaded by

Mauro Castaño
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Supplies needed:

A round piece of cardboard about 1 ft across (the cardboard from a


frozen pizza works well)

Lots of colors of oak tag (or construction paper)

Scissors

Tape

String

Pencil, crayons, or markers

A compass (for making circles)

Find the center of the large cardboard circle by


drawing a line from top to bottom and a line from
right to left. Where these two lines meet is the center
of the circle. This will be the position of the Sun.
Using a compass, draw the orbits of the 9 planets
(draw circles around the center of the piece of
cardboard).
The first 4 planets orbit relatively close to the Sun,
then there is a gap (this is where the asteroids orbit).
Then the last 5 planets orbit very far from the Sun.
Using an awl, the sharp point of scissors, or a large
nail, punch a series of holes in the cardboard. First
punch a hole in the center (this is where the Sun will
hang). Then punch one hole somewhere on each
circle (orbit); a planet will hang from each hole.

If you want an accurate picture of where the planets


actually are today, click here.

Cut circles from oak tag to represent the Sun and


each of the planets. Since the range in size of the
Sun and the planets is far too large to represent
accurately, just make the Sun the biggest. Make
Jupiter, Saturn, Uranus, and Neptune a bit smaller
than the Sun. Make the remainder of the planets
much smaller. Saturn has beautiful rings.
Write the name of each planet on its back.
Tape a length of string to each planet (and the
Sun).
Lace the other end of each string through the
correct hole in the large cardboard circle
(Mercury goes in the inner orbit, Venus goes in
the second orbit, Earth goes in the third, etc.).
Tape the end of the string to the top side of the
cardboard.
After all the planets (and the Sun) are attached,

adjust the length of the strings so that the planets


(and Sun) all lie in a plane.
To hang your model, tie three pieces of string to the
top of the cardboard - then tie these three together. Tie
them to a longer string (from which you'll hang your
model).
You now have a model of our solar system.

You might also like