Scribd
Upload
68 views2 pages

Tutorial-Create Spur Gears PDF

This document provides instructions for completing a tutorial on creating spur gears in Autodesk Inventor. It outlines starting a new Inventor project with the appropriate settings for the workspace, library, and content center files. It then instructs the user to follow the tutorial instructions but to save any modified files to the defined workspace rather than the folders in the tutorial. The last step is to create an assembly drawing file called MySpurGear.idw after finishing the rest of the tutorial.

Uploaded by

SanPer86
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
68 views2 pages

Tutorial-Create Spur Gears PDF

This document provides instructions for completing a tutorial on creating spur gears in Autodesk Inventor. It outlines starting a new Inventor project with the appropriate settings for the workspace, library, and content center files. It then instructs the user to follow the tutorial instructions but to save any modified files to the defined workspace rather than the folders in the tutorial. The last step is to create an assembly drawing file called MySpurGear.idw after finishing the rest of the tutorial.

Uploaded by

SanPer86
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Creating Spur Gears Tutorial

Project Management (Folders)


Create / use the appropriate Inventor project (see below)
1.
2.
3.
4.

Start Inventor
Close any open files
Select: Projects
Verify the appropriates settings
a. Workspace
b. Library
c. Content Center Files

Tutorial - File Management


1. Instructions for this tutorial are in the Autodesk Software
a. Select: Tutorials | Mechanical Design | Spur Gears Connections
2. Do not use the folders / project indicated in the tutorial. Use the folders / project
defined above
3. Required files are in the library. These files cant be modified
a. If the assemblies require modification, do the following
i. File | Save-As: save them into the workspace
b. If parts in the assembly require modification
i. Open / Edit the part
ii. File | Save-as: Save the part into the workspace
iii. Select the part in the model tree, replace it with the part that was saved
in the workspace
4. Continue with the rest of the tutorial.
5. Create the assembly drawing, see below

File: MySpurGear.iam

Files: MySpurGear.idw

You might also like