Scribd
Upload
2K views1 page

Introduction To ANSYS FLUENT

ANSYS Fluent software is used to model fluid flow, heat transfer, and chemical reactions across various industrial applications. This 4-day training course is intended for new users to learn how to model, mesh, set up simulations, solve models, and analyze results in ANSYS Fluent. The topics covered include CAD modeling, meshing, the GUI interface, boundary conditions, heat transfer, turbulence, and more. Hands-on workshops and exercises are included each day to help participants learn the software. The training will take place over 4 days from 9am to 5pm at CAD-IT Consultants in Kelana Jaya, Malaysia.

Uploaded by

Kang Qin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views1 page

Introduction To ANSYS FLUENT

ANSYS Fluent software is used to model fluid flow, heat transfer, and chemical reactions across various industrial applications. This 4-day training course is intended for new users to learn how to model, mesh, set up simulations, solve models, and analyze results in ANSYS Fluent. The topics covered include CAD modeling, meshing, the GUI interface, boundary conditions, heat transfer, turbulence, and more. Hands-on workshops and exercises are included each day to help participants learn the software. The training will take place over 4 days from 9am to 5pm at CAD-IT Consultants in Kelana Jaya, Malaysia.

Uploaded by

Kang Qin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Introduction to ANSYS Fluent

About ANSYS Fluent


ANSYS Fluent software contains the broad physical
modeling capabilities needed to model flow,
turbulence, heat transfer, and reactions for
industrial applications ranging from air flow over
an aircraft wing to combustion in a furnace, from
bubble columns to oil platforms, from blood flow
to semiconductor manufacturing, and from clean
room design to wastewater treatment plants.
Special models that give the software the ability to
model in-cylinder combustion, aeroacoustics,
turbomachinery, and multiphase systems have
served to broaden its reach.

About the Training


This course is intended for people who have had
little or no experience with ANSYS Fluent. New
users of the software should register for this 4
days course which includes how to model,
meshing, setup, solve and post-process your
results from ANSYS Fluent.

Who Should Attend


This course is designed for new users that wants to
get use to basic control and usage of Fluent.

Pre-requisites
A technical education and background is
recommended but an engineering degree is not
required.

Topics Covered

CAD Modelling for CFD


Meshing for CFD
Introduction and GUI Interface
Solver basics
Boundary conditions
Solver settings
Heat transfer
Turbulence
Multiphase
User Defined Functions (UDF)
Moving Zones

Each course chapter is followed by "hands-on"


workshops and exercises

Seminar Title
Training

Introduction to ANSYS Fluent (4 days)

Date
Date
Time
Time
Venue
Venue

Please refer to our website here


9.00 am to 5.00 pm
9.00 am to 5.00 pm
CAD-IT Consultants (M) Sdn Bhd
UPM
607, Block A, Kelana Centre Point,
Jln SS7/19, Kelana Jaya, 47301, Petaling Jaya, Selangor.

For more information, please call 03-7806 4758 or send your enquiry to [email protected]

CAD-IT Consultants (M) Sdn Bhd


www.cadit.com.sg
Bringing you tomorrows technology today!

You might also like