Scribd
Upload
617 views4 pages

Explosion Box Tutorial Scor Pal Feb 1 PDF

This document provides instructions for making an explosion box that contains 13 steps. The supplies needed are various sizes of cardstock and patterned paper. The instructions explain how to score and fold the cardstock to form the bottom, sides, and top of the box. Patterned paper is used to decorate the outside and inside surfaces. An optional inner box can be made by further scoring and cutting another piece of cardstock. Tags and pockets can be added for additional elements.

Uploaded by

Tiffany Teoh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
617 views4 pages

Explosion Box Tutorial Scor Pal Feb 1 PDF

This document provides instructions for making an explosion box that contains 13 steps. The supplies needed are various sizes of cardstock and patterned paper. The instructions explain how to score and fold the cardstock to form the bottom, sides, and top of the box. Patterned paper is used to decorate the outside and inside surfaces. An optional inner box can be made by further scoring and cutting another piece of cardstock. Tags and pockets can be added for additional elements.

Uploaded by

Tiffany Teoh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Explosion Box Tutorial: Beate Johns All Rights Reserved 2007

Supplies:
9 square of cardstock for box bottom
9 square of cardstock for box inside pages (optional)
5 1/8 square of cardstock for box top
Four 2 7/8 squares of patterned paper for box side decoration
Four 2 squares of patterned paper for inside decoration
Scor-Tape
Stamps, Ink and embellishments
Step 1:
Line up your 9 cardstock for the bottom of
the box on the top left of your Scor-Pal
and score at 3 and 6.

Step 2:
Turn your box bottom 90 degrees and
score again at 3 and 6. You will have
scored your cardstock into 9 even
squares.

Step 3:
Score your outside squares diagonally.
Pre-fold each score. The diagonal folds
will be pushed in toward the center to
make the box bottom.

Step four:
Tape your 2 7/8 pieces of patterned
paper on the square pieces that will make
the outside walls.

Step 5:
Cut your 2 squares of patterned paper
in half diagonally and tape on your outer
squares on the inside of your box bottom.

INNER BOX
Step 6: Score your 9 piece of cardstock
for the box inside pages at 3 and 6. Turn
90 degrees and repeat to score into nine
even squares.

Step7:
Cut your outer squares off, leaving a cardstock
cross. Cut 1/8 off each end of the cross.

Step 8:
Decorate the inside pages. Add tape to the center
square and tape into your box.

Step 9:
Take your 5 1/8 piece of cardstock and
stamp to decorate.
Score at 1 on each side.

Step10:
Cut four of the short scored lines as shown. It
will create small flaps. These will be your glue
taps.

Step 11:
Cut the glue tabs down a bit so they wont
show when you tape them down. Add ScorTape to each tab.

Step 12:
Tape your lid together.

Step 13:
Decorate your lid. Fold up the sides of the
box. Put on the lid and voil you have an
Explosion Box

If you wish to add pockets to the inside little box. Cut 1 3/4" x 2 7/8" piece
of designer paper. Add Scor-Tape on the bottom, the left and the right
edges. Do not tape down the top edge.

Tags: Cut 1 3/4" x 2 1/4" pieces of cardstock, trim to tags, add ribbon.

You might also like