Scribd
Upload
128 views

Bridge Design

The document provides design specifications for the exterior girder of a one-lane deck-girder reinforced concrete bridge, including bridge deck dimensions and material properties, interior T-beam dimensions and reinforcement details, loads from wearing surface, parapet, railing and vehicles, and concrete strength and rebar yield strength to use. The bridge is to be supported by 3 interior T-beams and have a 175mm thick deck slab.

Uploaded by

Melvin Esguerra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
128 views

Bridge Design

The document provides design specifications for the exterior girder of a one-lane deck-girder reinforced concrete bridge, including bridge deck dimensions and material properties, interior T-beam dimensions and reinforcement details, loads from wearing surface, parapet, railing and vehicles, and concrete strength and rebar yield strength to use. The bridge is to be supported by 3 interior T-beams and have a 175mm thick deck slab.

Uploaded by

Melvin Esguerra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Design the exterior girder of a one-lane deck-girder RC bridge using the following data:

Bridge Deck:
slab thickness = 175 mm
lane width (including sidewalk, shoulder, and parapet) = 5.4 m
bottom width of parapet = 0.6 m
Interior T-Beams
effective length = 12.5 m
depth = 875 mm
width of web = 350 mm
main reinforcement = 7 D32
distance between layers = 40 mm
shear reinforcement = 10 mm
concrete cover = 37.5 mm
resisting Moment = 1749.20 kN-m
Loads:
Dead Load:
Wearing surface = 0.80 kPa
Weight of parapet = 3.53 kN/m
Weight of railing = 0.25 kN/m
Live load:
MS 13.5
distance between mid-axle and rear axle = 5 m
The bridge is to be supported by 3 T-beams. Use
beams and slab.

f c' 27.6 MPa

and

f y 276 MPa

for all

You might also like