Scribd
Upload
38 views18 pages

Arduino: Presented By: Alejandra Castellanos

Arduino is a programmable microcontroller that can be used to prototype electromechanical devices by connecting sensors and actuators like LEDs or motors. It comes in different boards like the Arduino Uno and can be used for applications like building robots or interactive art installations. The Arduino software must be installed and configured for the microcontroller board and serial port before code can be uploaded to control inputs and outputs.

Uploaded by

sebastian gonzalez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
38 views18 pages

Arduino: Presented By: Alejandra Castellanos

Arduino is a programmable microcontroller that can be used to prototype electromechanical devices by connecting sensors and actuators like LEDs or motors. It comes in different boards like the Arduino Uno and can be used for applications like building robots or interactive art installations. The Arduino software must be installed and configured for the microcontroller board and serial port before code can be uploaded to control inputs and outputs.

Uploaded by

sebastian gonzalez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 18

Arduino

Presented by: Alejandra Castellanos

What is Arduino?
A programmable micro controller for prototyping
electromechanical devices
You can connect Digital and Analog electronic signals:

Sensors (Gyroscopes, GPS Locators, accelerometers)

Actuators (LEDS or electrical motors)

Different types of Arduinos

Boarduino Kit

DIY Arduino

Arduino Uno

Arduino LilyPad

Arduino Mega 2560

Applications
http://
www.youtube.com/watch?v=8dynrQv
F_bE
http://www.youtube.com/watch?v=m
w__
gOjdyYI
http://
www.youtube.com/watch?v=SmJEjFW

Arduino Components

What do we need?

1.- Download and install the Arduino


Software

2.- Configure the Arduino software for the


correct chip
(Select the Microcontroller)

3.- Configure the Serial Port

4.- Open Blink Sketch

Inpu
t
Program
Notificat
ion Area

Status
Bar

Code

5.- Verify/Compile

6.- Once it compiles, you must see the


following messages in the Status bar
and the Program notification Area

7.- Upload it

8.- Once it upload, you must see the


following messages in the Status bar
and the Program notification Area

Error
avrdude: stk500_getsync(): not in sync: resp=0x00

can't open device "COM10": The system cannot


find the file specified

9.- Insert LED

It is blinking!!!

DC Motor

https://www.facebook.com/photo.
php?v=645683978822637&set=vb.10
0001431223716&type=2&theater
#

You might also like