Scribd
Upload
839 views

Development of Surfaces

There are three methods for developing the surface of a 3D object onto a 2D plane: parallel line method for objects with constant cross-sections like prisms and cylinders, radial line method for right and oblique pyramids and cones using radial lines from the vertex to base corners, and triangulation. The development of a right cone is a sector of a circle with the central angle determined by the base radius and slant height. Several examples are given of developing different 3D shapes using these methods.

Uploaded by

Kishor Patil
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
839 views

Development of Surfaces

There are three methods for developing the surface of a 3D object onto a 2D plane: parallel line method for objects with constant cross-sections like prisms and cylinders, radial line method for right and oblique pyramids and cones using radial lines from the vertex to base corners, and triangulation. The development of a right cone is a sector of a circle with the central angle determined by the base radius and slant height. Several examples are given of developing different 3D shapes using these methods.

Uploaded by

Kishor Patil
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 6

Development of surfaces

A layout of the complete surface of a three dimensional object on a plane surface is called its development or pattern. Development is
a term frequently used in sheet metal work where it means the unfolding or unrolling of a detail into a flat sheet called a pattern
There are three methods of pattern development; (i) Parallel line, (ii) Radial line and (iii) Triangulation.
Parallel Line Method:
This method can only be used to develop objects (or parts thereof) having a constant cross-section for their full length, for example, prisms and
cylinders and related forms.
Parallel lines, parallel to the axis of the detail, are shown on a view which shows them as their true lengths.

Radial Line Method

Radial Line Method:


This method of development is used for right and oblique pyramids and cones. It employs radial lines which are slant edges from vertex to
base comer points for pyramids, and radial surface lines on the cone surface from the vertex to the base.
Development of Right Cones:
The development of any right cone is a sector of a circle since the radial surface Lines are all of the same true length. The angle at centre of the
sector depends on the base radius and the slant height of the cone. Let the radius of the base of the cone be R, the slant height of the cone be L,
and the angle at the centre of the development be .
= (Radius of the base circle /True slant length) X 360 =(R / L) X 360
1.
2.
3.

Draw the development of a square prism of side of base 30mm and height 50mm.
Draw the development of a cylinder of base diameter D=30mm and height of 35mm.
Draw the development of a cone base diameter D=50mm and height is 60mm

4.
5.
6.

Draw the development of pentagon prism edge 25mm and height 60mm.
Draw the development triangular pyramid base edge is 30mm and height 60mm.
Draw the development of Hexagon pyramid base edge is 25mm and height is 60mm.

7.
8.

Draw the development of the lateral surface of the frustum of the square pyramid of side of base 30 mm and axis 40 mm, resting on
HP with one of the base edges parallel to VP. It is cut by a horizontal cutting plane at a height of 20 mm.
Cylinder of diameter of base 40 mm and height 50 mm is standing on its base on HP. A cutting plane inclined at 45 to the axis of the
cylinder passes through the left extreme point of the top base. Develop the lateral surface of the truncated cylinder.

You might also like