Scribd
Upload
37 views

Assignment I - Embedded System

This document provides information about an assignment for an Embedded System Design course. It covers two units - Introduction to Embedded Systems and The Hardware Side. The assignment is divided into three sections - Section A has two 5-mark questions, Section B has two 5-mark questions, and Section C has five 1-mark questions. Students are required to submit the assignment by September 12th, 2013 for a maximum of 25 marks. The document also includes spaces for the class size, number of submissions, and faculty signatures.

Uploaded by

sarafnexus4
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
37 views

Assignment I - Embedded System

This document provides information about an assignment for an Embedded System Design course. It covers two units - Introduction to Embedded Systems and The Hardware Side. The assignment is divided into three sections - Section A has two 5-mark questions, Section B has two 5-mark questions, and Section C has five 1-mark questions. Students are required to submit the assignment by September 12th, 2013 for a maximum of 25 marks. The document also includes spaces for the class size, number of submissions, and faculty signatures.

Uploaded by

sarafnexus4
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Semester : VII

Max. Marks : 25

Subject : Embedded System Design


Assignment I
Div : A & B

Code : 10EC74
Issue Date : 05.09.2013
Submission Date : 12.09.2013

Units covered: Unit 1:Introduction to Embedded System


Unit 2:The Hardware Side
Section A (Max 2 questions of 5 marks each)

10 Marks

1. What is an Embedded System ? Define system bus, firmware, instruction set and realtime system.
2. Explain the core level architecture of the embedded system.

Section B (Max 2 questions of 5 marks each)

10 Marks

1. Discuss Embedded System life cycle with flow chart.


2. Design different addressing modes to be designed for the embedded system.
Section C
1.
2.
3.
4.
5.

What is an arity of the operator ?


What is watchdog timer?
X++ is -------------- type of instruction.
Name data transfer instructions.
What is next operation of processor control?

Class Strength :
No. of students submitted :
Signature of faculty member with date

Signature of HOD with date

Marks

You might also like