Scribd
Upload
137 views2 pages

Four Quadrant DC Motor Control Without Microcontroller: Abstract

The document describes a control system for a DC motor that allows operation in four quadrants without a microcontroller. It uses an H-bridge driver IC to demonstrate forward and reverse motoring as well as braking by reversing the armature voltage polarity. The system includes control buttons to set the motor to forward, reverse, forward brake, or reverse brake modes. It uses a 555 timer IC to impose a reverse voltage on a running motor, causing immediate stopping during forward or reverse operation.

Uploaded by

Pratik Sarkar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
137 views2 pages

Four Quadrant DC Motor Control Without Microcontroller: Abstract

The document describes a control system for a DC motor that allows operation in four quadrants without a microcontroller. It uses an H-bridge driver IC to demonstrate forward and reverse motoring as well as braking by reversing the armature voltage polarity. The system includes control buttons to set the motor to forward, reverse, forward brake, or reverse brake modes. It uses a 555 timer IC to impose a reverse voltage on a running motor, causing immediate stopping during forward or reverse operation.

Uploaded by

Pratik Sarkar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

MODEL NO: 241

FOUR QUADRANT DC MOTOR CONTROL WITHOUT


MICROCONTROLLER

ABSTRACT:

The aim of the project is to develop a control system for DC motor in four-quadrant operation.
Using a built in H-bridge driver IC it is possible to demonstrate forward &reverse motoring and
braking.
The operation of DC motor is directly proportional to armature voltage polarity and inversely
proportional to flux. By maintaining the flux constant, the direction can be changed by reversing the
armature voltage.
In this project, we use a small FHP (Fractional Horse Power) DC motor whose field comprises
of a permanent magnet. The armature of that is excited by the driver IC as stated.
The system is provided with various control keys, such as START, STOP, FORWARD,
REVERSE, FORWARD BRAKE, and REVERSE BRAKE. Using these keys, the user can set the
motor to run in any one of the following modes, namely Forward motoring, Reverse motoring, Forward
braking and reverse braking.
Using time IC 555 in monostabe to impose reverse voltage to a running motor for a very short
time results in immediate stop that happens both during forward and reverse run of the motor by the
motor driver IC

MODEL NO: 241

BLOCK DIAGRAM:

Block diagram of four-quadrant DC drive

HARDWARE REQUIREMENTS:
Uncontrolled rectifier using diodes, 555Timer,
Relays, Transistors, Motor Driver IC, DC
motor, Inverter IC, Push Buttons, Regulator,
and Transformer.

You might also like