Scribd
Upload
192 views10 pages

How To Set Up WiFi Hi3516c

1. To set up WiFi for an IP camera, install the Upgrade Tool and CMS software and run the Upgrade software to find the camera's IP address. 2. Access the camera's network settings through the CMS software and click on WiFi to open the WiFi configuration page. 3. Select your WiFi network and enter the password, set a unique IP address for WiFi, and click OK to finish the WiFi setting.

Uploaded by

Stephen Wilber
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
192 views10 pages

How To Set Up WiFi Hi3516c

1. To set up WiFi for an IP camera, install the Upgrade Tool and CMS software and run the Upgrade software to find the camera's IP address. 2. Access the camera's network settings through the CMS software and click on WiFi to open the WiFi configuration page. 3. Select your WiFi network and enter the password, set a unique IP address for WiFi, and click OK to finish the WiFi setting.

Uploaded by

Stephen Wilber
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 10

How to set up WiFi

Step 1: Connect your IP Camera into network.


Step 2: Install Upgrade Tool and CMS Software in your computer. The software can be found
in the CD.
Step 3: Run Upgrade software.

Step 4: Click IP Search to find the device you have connected. (If you did not change the IP
Address before, then its default address is 192.168.1.10)

Step 6: Select the IP address for the device you connected and click Modify to change the IP
Address. IP Address should be unique in the whole local network. Subnet Mask and
Gateway should be SameToPc.

Step 7: Run CMS Software.

Step 8: The Username & Password can be default. Username is super, and no need
password.

Step 9: Click System ----Device Manager to add surveillance Area and IP Camera.

Step10: Click Add Area to add surveillance zone. And Click OK.

Step11: Select the Zone Name you added and Click ADD DEVICE to add a IP Camera.

Step12: Click IP Search to find the device you connected. Select the IP address and Add Device
and then click OK.

Step11:

Click OK.

Step 12: Double Click the Device and drug the CAM01 to Channel 1.

Step 13: Choose Channel 1, and right Click the mouse and select Device Config.

Step 13: Right Click the mouse and select Device Config.

Step 14: Click Setting System Network NetService

Step 15: Click WiFi to open WiFi Config.

Step 16: Click Search to find the near WiFi. Selected your WiFi and input Password.

Step 16: Select the Enable. Set a unique IP Address for WiFi. Please note, this address should
not be same as the wired address. Then click OK. WiFi Setting has finished.

Step 17: Click the System ---Device Manager again to find the WiFi address you have just set
up.

Step 18: Click IP Search to find the IP Address you have just set up. Select the IP Address and

Click ADD Device to add the WiFi Address into the list.

Step 19: Double Click the Device and drug the CAM01 to Channel 2. So you can find two
IP Address for the same device. You can disconnect the RJ45 Cable and use WIFI only.

WiFi Setting has finished. Thank you!

You might also like