Scribd
Upload
114 views3 pages

Magnaflux Crack Comparators Assist in Measuring The Size of LPI Indications

Magnaflux crack comparators are used to accurately measure the size of cracks or indications found during liquid penetrant inspections. The document describes three comparator models: one measures cracks from 0.005 to 0.125 inches, another measures from 0.2 to 3.0 mm, and the third measures from 0.010 to 0.180 inches and meets Pratt & Whitney specifications. All comparators comply with relevant ASTM and other standards for non-destructive testing.

Uploaded by

Engr Arfan Ali Dhamraho
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
114 views3 pages

Magnaflux Crack Comparators Assist in Measuring The Size of LPI Indications

Magnaflux crack comparators are used to accurately measure the size of cracks or indications found during liquid penetrant inspections. The document describes three comparator models: one measures cracks from 0.005 to 0.125 inches, another measures from 0.2 to 3.0 mm, and the third measures from 0.010 to 0.180 inches and meets Pratt & Whitney specifications. All comparators comply with relevant ASTM and other standards for non-destructive testing.

Uploaded by

Engr Arfan Ali Dhamraho
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Crack Comparators

Magnaflux crack comparators assist in measuring the size of LPI indications.


Magnaflux crack comparators are used to measure the actual size of indications identified during the
LPI inspection process.
Our Comparator, 514048, measures crack sizes in inches ranging from 0.005" to 0.125". Comparator,
514049 measures crack sizes in metric units ranging from 0.2mm to 3.0mm and the Pratt & Whitney
Approved Comparator, 514050, measures crack sizes in inches between 0.010" to 0.180".
Part Numbers:

514048: General Purpose Comparator measured in increments 0.005" to 0.125"

514049: General Purpose Metric Crack Comparator measured in increments 0.2mm to 3.0mm

514050: Pratt & Whitney Crack Comparator measured in increments 0.010" to 0.180" and meets
Pratt & Whitney requirements ( P&W Reference - TAM 135273)

Specifications Compliance: ASTM E165, ASTM E1417, AMS 2647D, BPVC

P/N 514050
Pratt & Whitney Crack Comparators

P/N 514049
General Purpose Metric Comparator

P/N 514048
General Purpose Comparator

You might also like