Scribd
Upload
50 views1 page

SEC-A (Design Using MATLAB) (Any One) : Machine Design & Simulation Laboratory PCEL7304 (0-0-3) 2 EE 6

This document provides information on the Machine Design & Simulation Laboratory course with code PCEL7304 offered in the 6th semester of the Electrical Engineering branch. The course carries 2 credits and includes three sections - Section A focuses on the design of transformers and motors using MATLAB, Section B involves simulating power electronics circuits using SIMULINK, and Section C covers obtaining responses and designing controllers for feedback control systems using MATLAB and SIMULINK.

Uploaded by

Lalbahadur Majhi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
50 views1 page

SEC-A (Design Using MATLAB) (Any One) : Machine Design & Simulation Laboratory PCEL7304 (0-0-3) 2 EE 6

This document provides information on the Machine Design & Simulation Laboratory course with code PCEL7304 offered in the 6th semester of the Electrical Engineering branch. The course carries 2 credits and includes three sections - Section A focuses on the design of transformers and motors using MATLAB, Section B involves simulating power electronics circuits using SIMULINK, and Section C covers obtaining responses and designing controllers for feedback control systems using MATLAB and SIMULINK.

Uploaded by

Lalbahadur Majhi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

SUBJECT: MACHINE DESIGN & SIMULATION LABORATORY

CODE: PCEL7304

CREDIT : (0-0-3) 2

BRANCH: EE

SEMESTER: 6th

SEC-A (Design Using MATLAB) (Any one)


1. Design of single phase/3-phase transformers
2. Design of 3-phase induction motor
3. Design of 3-phase synchronous generator

SEC-B (Simulation Using SIMULINK) (Any two)


1. Simulation of 1-phase HW/FW Rectifier with R/RL Load
2. Simulation of 3-phase Controlled Rectifier with R/RL Load
3. Simulation of 1-phase/ 3-phase Inverter

SEC-C (Design/Simulation Using MATLAB/ SIMULINK) (Any two)


1. Obtaining time response of a given feedback control
system to unit step/ ramp input
2. Obtaining frequency response (Bode plot & Polar Plot) of a
given feedback control system
3. Design & Simulation of P / PI / PID Controller

You might also like