Scribd
Upload
38 views

Use "Shape Design": Use "Point" Creat Point 1 and Point 2 and Point 3 Use "Line" Connect Point 1 and Point 2

The document provides instructions for creating 3D models using various SolidWorks features. It first describes using points, lines, and a helix to create a shape, then using planes and pads to add thickness. Later instructions describe using extruded, swept, and mirrored features to create additional shapes, then using trim and fillets to refine the model. The overall purpose is to demonstrate how to construct 3D models through a series of sketching and feature creation steps.

Uploaded by

TekamantoaEzekielKaitu
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
38 views

Use "Shape Design": Use "Point" Creat Point 1 and Point 2 and Point 3 Use "Line" Connect Point 1 and Point 2

The document provides instructions for creating 3D models using various SolidWorks features. It first describes using points, lines, and a helix to create a shape, then using planes and pads to add thickness. Later instructions describe using extruded, swept, and mirrored features to create additional shapes, then using trim and fillets to refine the model. The overall purpose is to demonstrate how to construct 3D models through a series of sketching and feature creation steps.

Uploaded by

TekamantoaEzekielKaitu
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 21

Practice 1.

Use Shape design

Use Point creat Point 1 and Point 2 and Point 3


Use line connect Point 1 and Point 2

Use Helix

Go back Part design


Create Plane > Normal to curve

In xy-plane draw circle 30x50 , Use Pad

Select new Plane as your sketch and draw

Use Rib

Use thickness

Use Split

Use circular pattern

Practice 2.

Draw this sketch in zx plane

Create new plane

Draw this sketch in new plane

Use Point creat Point 1 and Point 2

Use "multi-section surface"

Draw this sketch in zx plane

Use Extruded

Draw this sketch in zx plane

Draw this sketch in xy


plane(use spline)

Use sweep
Profile->Sketch.5
Guide curve->Sketch.6

Use symmetry and mirror


sweep.1

Use Trim select two connect surface


And repeat the action in the other connect surfaces

Draw this sketch in


xy plane

Use Extruded

Draw this sketch in yz plane

Use Extruded

Use Trim cut you dont want

Use Edge Fillet

Finish

You might also like