Scribd
Upload
70 views5 pages

Pspice, ECE210, HCMUT

Analog signal Processing, Telecommunications, Electrical & Computer Engineerings, Pspice labs using OrCAD 9.2, Analog filter design, Ladder network.

Uploaded by

Ace Nhat
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
70 views5 pages

Pspice, ECE210, HCMUT

Analog signal Processing, Telecommunications, Electrical & Computer Engineerings, Pspice labs using OrCAD 9.2, Analog filter design, Ladder network.

Uploaded by

Ace Nhat
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Analog Signal Processing Fall 2012

Instructor : Dr Juan Alvarez


T.A : Trung Mai Van
Homework #3
Due Date : January 14th, 2013
Please noted that
is the right-most digit of your student ID. If

, take

is the second right-most digit of your student ID. If


For an example : if your student ID is ILI 110168,
your student ID is ILI 10008,
and

, take
and
.

. In the case,

1. Bias Point Simulation


Draw the circuits below in Capture CIS and then simulate them in Bias Point
Mode to work out the voltage at each node and current on the branch.

2. Thevenin or Norton equivalent circuit


2.1 Find the Thevenin voltage
, Thevenin resistance
current
of the following circuits between terminals a and b.

and Norton

a) Calculate the above quantities manually.


b) Using Pspice to check your calculations.
2.2 Find the Thevenin voltage
, Thevenin resistance
and Norton
current
of the following circuits between terminals a and b by using Pspice.

3. Maximum Power Transfer


Using Pspice to find the resistance of the load in order to receive the
maximum power from the circuit.

4. Operational Amplifier
Draw the circuit below with Capture CIS and then use Pspice to check the
transfer function of a commonly-used op-amps circuit.
Note : Use the OPAM component in Analog library.

Circuit 1 : Inverting Amplifier

Simulation No.
1
2

Hints : In the first simulation, you should perform with bias point mode but
transient mode works for the second.
5. Analog Filter Design
5.1

Using Matlab to design


specifications below

Butterworth

Low-pass

filter

with

the

Order : 2
Cut-off frequency :
Realize the transfer function worked out from Matlab by Sallen Key
Model for low-pass filter.

Test the result in Pspice with a AC sweep mode. The drawing must
show the transfer function in frequency domain with the y-axis scale in
dB and x- axis in Hz.

5.2

Design a low-pass filter using ladder network with the specifications


below follow the design table and procedure come with the slides
introduced about Analog Filter Design.
Order : 5
Cut-off frequency : 3 KHz
Realize the circuit in Pspice and check its frequency response in AC
Sweep mode.

You might also like