0% found this document useful (0 votes)
92 views1 page

Quiz1 Solutions

The document is a quiz for an automatic control systems course. It contains questions about the general requirements of control systems, the difference between open loop and closed loop control, and identifying components in a feedback control system block diagram. Specifically: The general requirements of control systems are that the system must be stable, the output must track the reference input signal, and the system must be prevented from responding too much to disturbances and noise. Closed loop control uses feedback of the output signal, whereas open loop control does not use feedback. The block diagram identifies the reference, controller, system or plant, output, error, input, measurement unit, feedback signal, and symbols for addition and subtraction.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
92 views1 page

Quiz1 Solutions

The document is a quiz for an automatic control systems course. It contains questions about the general requirements of control systems, the difference between open loop and closed loop control, and identifying components in a feedback control system block diagram. Specifically: The general requirements of control systems are that the system must be stable, the output must track the reference input signal, and the system must be prevented from responding too much to disturbances and noise. Closed loop control uses feedback of the output signal, whereas open loop control does not use feedback. The block diagram identifies the reference, controller, system or plant, output, error, input, measurement unit, feedback signal, and symbols for addition and subtraction.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

UCK 362E: AUTOMATIC CONTROL

QUIZ # 1

10. February.2014

1- What is the general requirements of Control? (3 Point)


* The system must be stable; doesn't produce unacceptably large signals.
* The system output must track the reference input signal.
* The system must be prevented from responding too much to disturbances and noise.
* The above three goals must be met even if the model used in the design isn't completley
accurate orif the dynamics of the physical system change overtime.

2- Difference between Open Loop control and Closed Loop Control1 ? (2 Point)

Open Loop Control hasn't got feedback of output signal but Closed Loop Control has.

3- What is the following letters stand for in feedback control system? (3 Point)
Reference
Controller
System(plant)
Output
Error
Input

A +

_
B Feedback
Signal

Measurement Unit

Figure 1: Closed -Loop Feedback Control System

4- Please find

Assumptions:

2-3 sentences only

in the following operational amplifier circuit? (2 Point)

You might also like