This alarm is triggered when the RNC is unable to activate a UTRANCELL due to a misconfiguration of the local cell ID on the RBS. The alarm indicates to check the cell ID on both the RNC and RBS, correct any mismatches, and save the configuration to clear the alarm and unlock/enable the affected cells.
This alarm is triggered when the RNC is unable to activate a UTRANCELL due to a misconfiguration of the local cell ID on the RBS. The alarm indicates to check the cell ID on both the RNC and RBS, correct any mismatches, and save the configuration to clear the alarm and unlock/enable the affected cells.
This alarm is triggered when the RNC is unable to activate a UTRANCELL due to a misconfiguration of the local cell ID on the RBS. The alarm indicates to check the cell ID on both the RNC and RBS, correct any mismatches, and save the configuration to clear the alarm and unlock/enable the affected cells.
This alarm is triggered when the RNC is unable to activate a UTRANCELL due to a misconfiguration of the local cell ID on the RBS. The alarm indicates to check the cell ID on both the RNC and RBS, correct any mismatches, and save the configuration to clear the alarm and unlock/enable the affected cells.
Download as DOCX, PDF, TXT or read online from Scribd
Download as docx, pdf, or txt
You are on page 1/ 1
UtranCell_RBSLocalCellNotAdded:
RNC Library in ALEX: Operation and Maintenance -> Fault Management -> Alarms ->UtranCell_RBSLocalCellNotAddedThis alarm is triggered when the RNC is trying to activate the UTRANCELL but is unable to as thereis a mis-configuration with the RBS Local Cell on the RBS. The alarm tranCell_NbapMessageFailurecould also be present for the affected sectors. RNC: moshell XXRNCX *log onto the RNClt all *load all Managed Objectsalt *show current alarmslst .xxxx *show status of channels
cells will be UNLOCKED and DISABLEDget cell=xxxx cid *check the Cell ID on the RNC RBS: moshell Uxxxx *log onto the nodelt all *load all Managed Objectsalt *show current alarms and confirm what sector is affected get rbslocalcell cellid *check the Cell ID on the RBS and confirm the mismatchConfirm the correct Cell ID to be used
CI Allocation Lookup
If the RBS that has the incorrect values use the following command to correct it:set rbslocalcell=SXCX localCellId=xxxxx *corrects the Cell ID on the RBSNOTE:S1C1
Sector 1,Carrier1S1C2
Sector1,Carrier2 etc.....If the RNC has the incorrect value use the following command to correct it:set cell=xxxxA1 cid=xxxxx *corrects the Cell ID on the RNCConfirm alarm has cleared and the cells are UNLOCKED and ENABLED.Finally be sure to save a CV
see Node B Restart Procedure for help on creating a CV.cvlscvms [cvname_date_time][ursername]
