Scribd
Upload
46 views2 pages

Power System Practical Assignment

This document contains an assignment on power system analysis with 3 questions. Question 1 asks to find the admittance matrix for a given system using a pi model representation for transmission lines. Question 2 asks to obtain node equations and form an admittance matrix for a given network. Question 3 asks to derive the admittance matrix for a 3 bus system shown in the figures, also using a pi model representation for the transmission lines.

Uploaded by

Samundra Gurung
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
46 views2 pages

Power System Practical Assignment

This document contains an assignment on power system analysis with 3 questions. Question 1 asks to find the admittance matrix for a given system using a pi model representation for transmission lines. Question 2 asks to obtain node equations and form an admittance matrix for a given network. Question 3 asks to derive the admittance matrix for a 3 bus system shown in the figures, also using a pi model representation for the transmission lines.

Uploaded by

Samundra Gurung
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Assignment -1, Power System Analysis-2, Year-III, Part-I, BEL-2069

Last date of submission: 4th December 2014


Q1. Find the admittance matrix for the system. Its given that all the lines are characterized by a
series impedance of 0.1+j0.7/Km and a shunt admittance of j0.35*10-5 /km. Lines are rated at
220kV and 100MVA. Use nominal - method for transmission line representation.

Q2. For the network given below, obtain node equations and then form admittance matrix
(Ybus). All impedances and voltages are marked in pu.

Q3. Figure 1 shows single diagram of a practical three bus system connecting Pokhara
substation. Transmission line uses bear conductor which has resistance of 0.11/km and
diameter of 23.45mm. These lines are connected using single circuit tower whose dimensions are
given in fig. 2. Derive the admittance matrix of this 3 bus system. Lines are rated at 132kV and
100MVA. Use nominal - method for transmission line representation.

Fig.1 Three bus System


(

Fig. 2 Single circuit configuration

GMR = 0.7788 * R, R is the radius of conductor

You might also like