Scribd
Upload
38 views

Tutorial 3b

This document contains 5 questions about circuit analysis: (1) Analyze a series RLC circuit, finding its resonant frequency, half-power frequencies, and current amplitudes. (2) Calculate power quantities for a load drawing power from a sinusoidal source. (3) Determine the inductance and resistance of a coil based on voltage, current, and power measurements. (4) Calculate the average power delivered to a resistor given its current over time. (5) Verify power conservation in a series RLC circuit driven by a voltage source.

Uploaded by

miindsurfer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
38 views

Tutorial 3b

This document contains 5 questions about circuit analysis: (1) Analyze a series RLC circuit, finding its resonant frequency, half-power frequencies, and current amplitudes. (2) Calculate power quantities for a load drawing power from a sinusoidal source. (3) Determine the inductance and resistance of a coil based on voltage, current, and power measurements. (4) Calculate the average power delivered to a resistor given its current over time. (5) Verify power conservation in a series RLC circuit driven by a voltage source.

Uploaded by

miindsurfer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Tutorial 3b

Question 1

20 sin t

Fig Q1
In the circuit in Fig Q1, R = 2, L = 1mH and C = 0.4F.
(i)
(ii)
(iii)

Find the resonant frequency 0, and the half power frequencies 1 and 2.
Calculate the quality factor and bandwidth.
Determine the amplitude of the current at 0, 1 and 2.

Question 2
A load Z draws 12 kVA at a power factor of 0.856 lagging from a 120 V rms sinusoidal
source. Calculate:
(i)
(ii)
(iii)

average and reactive powers delivered to the load


the peak current
the total load impedance

Question 3
a) A coil is represented by a model consisting of an inductance L in series with a
resistance R. A voltmeter reading rms voltage reads 26 V when a 2-A (rms)
current is supplied to the coil. A wattmeter indicates that the average power
delivered to the coil is 20 W. Determine L and R when = 377 rad/s.
b) Assume the coil in (a) is connected to a 26-V (rms) source at the frequency =
377 rad/s. Find the complex power delivered to each element of this circuit.
Verify the principle of conservation of complex power.

Question 4
Find the average power delivered to a resistor R, the current through the resistor i (t) is
shown in Fig. Q 4.
Im

2T

t (sec.)

Fig. Q 4
Question 5
Verify that average power is conserved in the circuit of Fig. Q 5
L

R
+
Vs

VR

VL

+
VC

i (t)

Fig. Q 5
For Vs = 10 cos 1000t V, R = 100 , L = 20 mH, and C = 10 F.

You might also like