Scribd
Upload
90 views1 page

Open Loop and Close Loop Testing in LTE

Open loop testing in LTE involves transmitting data without feedback from the receiver, allowing testing of individual components but not complete verification. Closed-loop testing enables retransmission of lost packets based on real-time feedback from the receiver about modulation, coding, and scheduling to optimize performance in real conditions. This provides a more detailed test through a feedback channel between the transmitter and receiver.

Uploaded by

Azmat Gaad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
90 views1 page

Open Loop and Close Loop Testing in LTE

Open loop testing in LTE involves transmitting data without feedback from the receiver, allowing testing of individual components but not complete verification. Closed-loop testing enables retransmission of lost packets based on real-time feedback from the receiver about modulation, coding, and scheduling to optimize performance in real conditions. This provides a more detailed test through a feedback channel between the transmitter and receiver.

Uploaded by

Azmat Gaad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Open loop and close loop testing in LTE

Here I write short notes on how to test open loop and close loop testing in lte and what idea
behind it. In open loop no any data send back and in closed loop all relevant data available to
both side lets check in some detail.
Open and close loop testing in LTE:
Open loop test where no test receiver sends feedback information source is sufficient to prove the
fundamental characteristics of the individual components in the receiver and is also a first step in
validating algorithms baseband demodulation section. However, complete verification.
Overall performance testing in real conditions receiver require closed loop through a channel off.
Closed-loop test packets lost packets are re transmitted using incremental redundancy based on
real-time information from the receiving confirmation.
Modulation and coding used for transmission also based on real-time information from the
receiver. This feedback can be optimized for sub bands overall bandwidth channel to enable
frequency selective scheduling.
This is very basic funda behind Open loop and close loop testing in LTE for more details check
my old article on open loop testing in lte and close loop testing in lte individual.

You might also like