Scribd
Upload
32 views1 page

E Ea As Sy Yp Piic C3 3: Mikroelektronika

The document describes the features of the EasyPIC3 development tool for Microchip PIC microcontrollers. It supports a wide range of PIC MCU package types from DIP8 to DIP40 and can communicate via RS232, USB, or receive PC keyboard input. Additional features include an onboard USB programmer, selection of external or USB power supply, temperature and potentiometer sensors, LED and seven segment digit control, and a graphic LCD connector.

Uploaded by

cesare.alceste
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
32 views1 page

E Ea As Sy Yp Piic C3 3: Mikroelektronika

The document describes the features of the EasyPIC3 development tool for Microchip PIC microcontrollers. It supports a wide range of PIC MCU package types from DIP8 to DIP40 and can communicate via RS232, USB, or receive PC keyboard input. Additional features include an onboard USB programmer, selection of external or USB power supply, temperature and potentiometer sensors, LED and seven segment digit control, and a graphic LCD connector.

Uploaded by

cesare.alceste
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

MikroElektronika

Tools-Compilers-Books
www.mikroelektronika.co.yu

RS232 communication
with selectable TX and
RX.

USB communication for


MCU with USB on-chip
fasilities.

Very fast and flexible


USB 2.0 programmer on
board.

Setting jumper to the


upper position sets the
pins of the appropriate
port to logical one (pullup). If jumper is set to
the lower postion, pins
are set to logical zero
(pull-down).

Choose between
external or USB power
supply. With USB power
supply, you dont need
external supply.
Temperature sensor
DS1820 can be on RE2
or RA5 pin

JP4 JP3
For microcontrollers
in DIP40, DIP18
and DIP28 package

Turns ON/OFF LEDs


on A, B, C, D and E
ports. Turns ON/OFF
Seven segmnet digits.

JP4 JP3
For microcontrollers
in DIP14 and DIP8
package

EasyPIC2 supports
microcontroller in
DIP8, DIP14, DIP18,
DIP28 and DIP40
package, which
makes you ready for
almost the entire
scope of Microchip
Microcontrollers.

Reset circuit

Chose how pressing the


button will affect the pin,
high state or low state.

Development tool for Microchip PIC MCUs

RA2 and RA3 can be


connected to potentiometers P2 and P3.
Port A is connected to
the resistor network,
using SW1. If SW1
switch is not in ON position, the appropriate pin
has neither pull-up
or pull-down resistor
attached.

External power supply


from 7 to 15 V DC/ AC.

EasyPIC3

PC keyboard input.

GLCD/LCD
contrast

Graphic LCD connector

MikroElektronika : Microcontrollers Development tools - Compilers - Books

You might also like