Scribd
Upload
25 views

Assignment 2012 4

This document contains mechanical measurement and metrology questions about various tools and gauges including auto-collimators, tool maker's microscopes, profile projectors, clinometers, and Parkinson Gear Testers. It also asks about thread gauges like plug screw gauges, ring screw gauges, and caliper gauges. Additional questions cover the three wire method for checking screw pitch diameter, using slip gauges and the sine bar to measure a taper plug gauge cone angle, interchangeability and its importance, designing Go and No Go gauges, and elements of surface roughness.

Uploaded by

Ashley_Rulzzzzzzz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
25 views

Assignment 2012 4

This document contains mechanical measurement and metrology questions about various tools and gauges including auto-collimators, tool maker's microscopes, profile projectors, clinometers, and Parkinson Gear Testers. It also asks about thread gauges like plug screw gauges, ring screw gauges, and caliper gauges. Additional questions cover the three wire method for checking screw pitch diameter, using slip gauges and the sine bar to measure a taper plug gauge cone angle, interchangeability and its importance, designing Go and No Go gauges, and elements of surface roughness.

Uploaded by

Ashley_Rulzzzzzzz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Subject : Mechanical Measurement & Metrology.

Class: T.E.(Mech-B) Sem V


Module 5 & 6
Q 1 Write a short note on
(a) Auto-collimator
(b) Tool makers microscope
(c) Profile projector.
(d) Clinometer
(e) Parkinson Gear Tester
Q.2 Explain the following forms of thread gauges
(a) Plug screw gauge
(b) Ring screw gauge
(c) Caliper Gauges.
Q.3 Explain the three wire method for checking the pitch diameter of screw.
Q.4 Explain use of slip gauges. Show setup for measurement of cone angle of a taper plug gauge
using sine bar.
Q.5 Write short note on:
i) Interchangeability and its importance
ii) Design of Go & No Go gauges
iii) Elements of surface roughness

You might also like