Scribd
Upload
124 views1 page

Restrictions AOP30 en

This document contains supplementary conditions and notes for SINAMICS DCM V1.4 that are binding and important to read carefully. It summarizes issues and workarounds for different error codes, including parameter p400 showing too many encoder types, the optimization run screen lacking a "next" option, and the ALARM LED sporadically blinking. The notes provide technical information on installing and using the SINAMICS DCM V1.4 system.

Uploaded by

Ricardo Ramirez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
124 views1 page

Restrictions AOP30 en

This document contains supplementary conditions and notes for SINAMICS DCM V1.4 that are binding and important to read carefully. It summarizes issues and workarounds for different error codes, including parameter p400 showing too many encoder types, the optimization run screen lacking a "next" option, and the ALARM LED sporadically blinking. The notes provide technical information on installing and using the SINAMICS DCM V1.4 system.

Uploaded by

Ricardo Ramirez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SIEMENS

AOP 30 for SINAMICS DCM V1.4

Supplementary conditions and functional restrictions as well as notes on configuration and operation.
These notes are binding to a higher level order than statements quoted in other documents.
Please read the notes carefully since they contain important information on the installation and the use of the system.

AOP 30 for SINAMICS DCM V1.4


ErrorID
Short description
AOP 30 for SINAMICS DCM V1.2
B340
Parameter p400 shows too many
encoder types.
B340

Optimization run does not offer a


"next" option to exit the screen.

B228

ALARM-LED blinking

Issue

Workarounds

As from version

Parameter p400 shows too many


encoder types. Also encoders that
are not supported by the encoder
evaluation of the DCM.
All the previous screens of the
wizard have a "next" option at the
end of them for navigation. For the
optimization runs the screen has to
be exited with "0: no optimization
run".
Sporadically the ALARM LED is
blinking and only a reduced
appears.

With the numerical input of 3000


you can quickly jump to the
beginning of the supported
encoders.
Exit screen with "0: no
optimization run".

DCM V1.2

Restart the AOP (e.g. by


pressing and releasing the red
OFF-pushbutton while pressing
the key- and +/--pushbutton.

DCM V1.4

Supplementary conditions for SINAMICS DCM V1.4

Page 1 of 1

DCM V1.2

24/07/2013

You might also like