Scribd
Upload
450 views

Multiecuscan User Guide

Multiecuscan User Guide

Uploaded by

csinszki
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
450 views

Multiecuscan User Guide

Multiecuscan User Guide

Uploaded by

csinszki
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 3
The interface can be with either USB or Serial connection to the computer. In both cases it is recognized by the computer as a serial port! NOTE: You can check the following link to see what type of adapters/modification you will need for your car: http://www.multiecuscan.net/SupportedVehiclesList.aspx Installation Notes: First, you need to install the serial port driver for the interface. The driver is usually supplied with your interface. If you don’t have a driver then you can try to download and install drivers from FTDI site. http://www ftdichip.com/Drivers/CDM/CDM20814 Setup.exe ‘After successful installation of the drivers you have to change the default configuration of the installed serial port to make it work properly. Go to Windows’ Device Manager and Double-click on USB Serial Port (or right-click and select Properties). JQ he constr ~Felfsaxt ea Yew Tos te et nan Snes ono I raxeeesaenyae 7 (Btsvoee B compar dita Dvn/c.RoM ave © By hn Price Dee BDEAINATAIconotes eee SBAKOUE 20 Comers ~ Keon © D vce oer iin eves og Meiers § ones newonasortes ° sou acon areconees Sapecomolee Multiecuscan User Guide Page 3 of 63 Go to Port Settings and click Advanced Multiecuscan User Guide Page 4 of 63 If you have a built-in serial port or PL2303 USB serial port you will need to lower the buffers to minimum as shown on the next screenshot. Note that for PL2303 USB serial port you will need to modify some registry settings in order to make it support 10400 bps. ‘vanced Setings fr CONS Use Probate aque S58 conga UA) Seca setogstoatgeromane ecw Biter Lon Tami iter ont coupearoncer (Com > ‘Woagiour Now, after changing these settings, you have to set the Interface Type to K-Line/VAGCOM in the Settings window of Multiecuscan. You also have to set the correct Serial port. This is a more advanced type of interface which supports multiple protocols. ELM 327 version 1.3 and newer is required for connection to the CAN network of the vehicle. PLEASE NOTE THAT THE VERSION MARKING ON THE CHINESE ELM 327 INTERFACES IS NOT THE SAME AS THE GENUINE ELM INTERFACES. With this type of interface you can connect to all supported modules except for most of the old Airbag modules and some old ABS and engine modules. In order to connect to ABS, Airbag, Power Steering and XENON modules you need to have an adapter cable, or you need to modify your interface. Multiecuscan User Guide Page 5 of 63

You might also like