Scribd
Upload
99 views

Txtopper QRP Amp PCB Layout: Viewed From Component Side of The Board

This document provides a layout diagram for the TxTopper QRP Amp PCB. The diagram shows the component placements and connections for an RF amplifier circuit board that is 2.6 inches wide and 1-15/16 inches tall. Key components include transistors Q1 and Q2, inductors L1 and L2, capacitors C1-C12, resistors R1-R10, and diodes D1-D5. The layout fits within the target dimension of a TTT-2 PCB and can be used for component placement or PCB fabrication.

Uploaded by

DefaultAnomoly
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
99 views

Txtopper QRP Amp PCB Layout: Viewed From Component Side of The Board

This document provides a layout diagram for the TxTopper QRP Amp PCB. The diagram shows the component placements and connections for an RF amplifier circuit board that is 2.6 inches wide and 1-15/16 inches tall. Key components include transistors Q1 and Q2, inductors L1 and L2, capacitors C1-C12, resistors R1-R10, and diodes D1-D5. The layout fits within the target dimension of a TTT-2 PCB and can be used for component placement or PCB fabrication.

Uploaded by

DefaultAnomoly
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

TxTopper QRP Amp PCB Layout

2.6 in.
C12
Gnd

C4

C6
L2

C5

D1

Q1
R7

L1

C3

Jumper
RF Out

C1

reppoTxT
80/3 JSU5W

1-15/16
K1

D4

T1

C2
C7

R8

R1

Gnd

R6

R3

R4

R2

Jumper
RF Out

RF In

R5
R10

C8

D3

C9

Q2

RF In

R9

D2

C11

B
C

C10

D
B

2.4 in.
Target Dimension

Rectangle fits within TTT-2 PCB Diameter


D5

Viewed from component side of the board.


Layout can be used for Manhatten pad locations or PCB etch and drill pattern

You might also like