Scribd
Upload
31 views

If You Want To Then : Related

This procedure describes how to modify the layout of a flexible duct run drawn using spline segments by moving, adding, or deleting vertices along the spline. You can select the flexible pipe segment and use the Flex Pipe Modify command to edit the vertices by entering commands like v to edit vertices, n to toggle between them, and m to move a vertex to a new location. The tangent at start/end, connecting to other parts, removing/inserting vertices can also be modified by specifying additional commands.

Uploaded by

Piulitza88
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
31 views

If You Want To Then : Related

This procedure describes how to modify the layout of a flexible duct run drawn using spline segments by moving, adding, or deleting vertices along the spline. You can select the flexible pipe segment and use the Flex Pipe Modify command to edit the vertices by entering commands like v to edit vertices, n to toggle between them, and m to move a vertex to a new location. The tangent at start/end, connecting to other parts, removing/inserting vertices can also be modified by specifying additional commands.

Uploaded by

Piulitza88
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Use this procedure to modify the layout of a flexible duct run that was drawn using the spline

segment mode. You can


modify the layout by moving, adding, or deleting vertices along the spline. (prin micare, adugarea sau tergerea nodurile
de-a lungul curbei
RELATED:For flexible pipe that was drawn using any of the segment modes (line, arc, or spline), you can use grips to move
the location of control points.(Pentru evi flexibile, care a fost elaborat folosind oricare dintre modurile de segment (linie,
arc, sau spline), putei utiliza mnere pentru a muta locaia de puncte de control) Select the flexible pipe segment, select a
location grip, and move it to a new location.
1. Select the flexible pipe segment.
2. Right-click, and click Flex Pipe Modify.
3. Enter v to edit the vertices of the spline. (ntroducei v pentru a edita nodurile curbei)
4. Enter n to toggle through the vertices along the spline. (ntroduceti n pentru a comuta, schimba ntre nodurile dea lungul curbei)
5. When you get to the vertex that you want to modify, specify the change:
If you want to

then

change the tangent at the start or end of the


segment

toggle to the start or end vertex on the flex pipe segment. Enter
t, and specify the new tangent for the start point or endpoint.

connect one end of a flex pipe to another part,


such as a pipe segment, pipe fitting, or MvPart

toggle to the start or end vertex on the flex pipe segment. Enter
c, and specify the part to which to connect.

move a vertex (nod)

enter m, and move the vertex to a new location.

remove a vertex

enter r.

insert a new vertex

enter i, and specify the insertion point for the new vertex.

update the view based on your changes

enter g.

exit the vertex mode

enter x.

6. In the Modify Flex Pipe dialog, click OK.

You might also like