Scribd
Upload
35 views2 pages

Assignment 1: MCB 3073 Manufacturing Technology 2 (Submit Before: 23 June 2014, 3 PM, at Block 19)

This document is an assignment for a manufacturing technology course. It provides instructions for students to calculate: (1) the maximum possible draft of rolling an aluminum plate from 100mm to 85mm thickness, (2) whether a single roll is possible and why, (3) the force required for rolling using an average true stress of 250MPa, and (4) whether rolling at 300°C is considered cold or hot rolling. Students are also asked to compare the microstructures formed from rolling at room temperature versus 300°C.

Uploaded by

Eileen Wong
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
35 views2 pages

Assignment 1: MCB 3073 Manufacturing Technology 2 (Submit Before: 23 June 2014, 3 PM, at Block 19)

This document is an assignment for a manufacturing technology course. It provides instructions for students to calculate: (1) the maximum possible draft of rolling an aluminum plate from 100mm to 85mm thickness, (2) whether a single roll is possible and why, (3) the force required for rolling using an average true stress of 250MPa, and (4) whether rolling at 300°C is considered cold or hot rolling. Students are also asked to compare the microstructures formed from rolling at room temperature versus 300°C.

Uploaded by

Eileen Wong
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Assignment 1

MCB 3073 Manufacturing Technology 2


(Submit Before: 23 June 2014, 3 pm, at Block 19)
Nama:.

Student ID:

Aluminium plate (thickness= 100 mm, width= 5000 mm, melting point = 660 0C) is rolled at room temperature to achieve the
thickness of 85 mm. Diameter of rolled used is 1 m with the coefficient of friction is 0.2.
a. Calculate the maximum possible draft of the process. [3 MARKS]
b. Is it possible to do a single rolling from 100 to 85 mm? Why? [1 MARK]
c. Calculate the force required (N) to do rolling process if the average true stress is 250 MPa. [2 MARKS]
d. If the process is done at 3000C, determine whether it is cold rolling or hot rolling. [2 MARKS]
e. Compare the microstructure formed by rolling at room temperature and at 3000C. [2 MARKS]
Answer:
1.

You might also like