Scribd
Upload
94 views3 pages

Electronic Combination Lock Using IC LS 7220

This circuit uses an LS7220 IC to create an electronic combination lock that activates a relay when a preset 4-digit combination is entered using switches. The combination is set by connecting switches to specific IC pins. When the correct combination is pressed, the output will be activated for approximately 6 seconds as determined by capacitor C1. A 3x4 matrix of switches can be used as a keypad, with symbols instead of numbers written on them to confuse anyone trying to guess the combination.

Uploaded by

Khaled Mahmud Bhuiyan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
94 views3 pages

Electronic Combination Lock Using IC LS 7220

This circuit uses an LS7220 IC to create an electronic combination lock that activates a relay when a preset 4-digit combination is entered using switches. The combination is set by connecting switches to specific IC pins. When the correct combination is pressed, the output will be activated for approximately 6 seconds as determined by capacitor C1. A 3x4 matrix of switches can be used as a keypad, with symbols instead of numbers written on them to confuse anyone trying to guess the combination.

Uploaded by

Khaled Mahmud Bhuiyan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Electronic Combination Lock using IC LS 7220

Electronic Combination Lock Circuit


Description
This is the circuit diagram of a simple electronic combination lock using IC LS 7220.This
circuit can be used to activate a relay for controlling (on & off) any device when a preset
combination of 4 digits are pressed.The circuit can be operated from 5V to 12V.
To set the combination connect the appropriate switches to pin 3,4,5 and 6 of the IC
through the header.As an example if S1 is connected to pin 3, S2 to pin 4 , S3 to pin 5, S4 to
pin 6 of the IC ,the combination will be 1234.This way we can create any 4 digit
combinations.Then connect the rest of the switches to pin 2 of IC.This will cause the IC to
reset if any invalid key is pressed , and entire key code has to be re entered.
When the correct key combination is pressed the out put ( relay) will be activated for a
preset time determined by the capacitor C1.Here it is set to be 6S.Increase C1 to increase
on time.
For the key pad, arrange switches in a 3X4 matrix on a PCB.Write the digits on the keys
using a marker.Instead of using numbers I wrote some symbols!.The bad guys will be more
confused by this.

yzyz

Electronic Lock Circuit Diagram .

Pin Assignment of LS7220.

Parts List
C1
C2
R1
Q1
D1
K1
U1
S1-S12
HD1

1
1uF 25V Electrolytic Capacitor
1
220uF
25V
Electrolytic
Capacitor
1
2.2K
1/4W
Resistor
1
2N3904
NPN
Transistor
2N2222
1
1N4148
Rectifier
Diode
1N4001-1N4007
1
12V SPDT Relay
Any appropriate relay with 12V coil
1
LS7220
Digital
Lock
IC
12
SPST
Momentary
Pushbutton
Keypad
(see
notes)
1 12 Position Header

You might also like