Scribd
Upload
417 views15 pages

How To Plot PCI On Nemo Analyze

This document provides instructions for plotting PCI measurements from log files in Nemo Analyze. It describes selecting log files and parameters, plotting the data on a map, troubleshooting issues with plot offsets, and exporting the plotted data to a tab file. The steps are the same for plotting other key performance indicators by searching for and selecting the desired parameter in the workspace.

Uploaded by

ReNz Gonzales
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
417 views15 pages

How To Plot PCI On Nemo Analyze

This document provides instructions for plotting PCI measurements from log files in Nemo Analyze. It describes selecting log files and parameters, plotting the data on a map, troubleshooting issues with plot offsets, and exporting the plotted data to a tab file. The steps are the same for plotting other key performance indicators by searching for and selecting the desired parameter in the workspace.

Uploaded by

ReNz Gonzales
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 15

PCI plotting

Nemo Analyze

Prepared by:
Mikhael Gabriel S. Gonzales,EcE
Support Engineer - Versatest Solutions & Services Inc.

Selecting of Log Files


Select all necessary Log Files needed
You may use the search panel under the Measurements

Selecting of Log Files

Parameters
On the Workspace search for the parameter/KPI needed to be shown
In this case, PCI, look for Physical cell identity under the LTE

Parameters

Plotting
You can now drag and drop the KPI onto the Workbook or right-click,
then Open In > Map
You may load an OpenStreetMap by right-clicking on the Workbook,
then Map > OpenStreetMap
Or load a tab file for the map by right-clicking on the Workbook, then
Add > Map Layer then select the designated tab file

Plotting

Troubleshooting
You may need to select a single log file first to be able to open it in
Map
After then you may select all logfiles then drag it to the map

But before dragging all the logfiles make sure to delete the map layer
with single measurement, to avoid offsetting the plot on the map

Troubleshooting

Troubleshooting
Make sure to
delete first the
map layer with
single
measurement
before plotting
ALL the logfiles

Troubleshooting
After plotting correctly, notice the color legends are different from
which is plotted on the map
To fix this, just click the map layer then it will change to the correct
color legend

Troubleshooting

Just click the map


layer once to
fix/match the
color legend

Final Result

Exporting to tab file


Right-click the
map layer then
Export Data To >
MapInfo Tab file

Note
For the plotting of different KPIs the steps are the same :

RSRP
SNR
PDSCH Throughput
PUSCH Throughput
PDSCH modulation codeword 0

Just search the necessary KPI on the search panel on the Parameters
under the Workspace then repeat the steps.

You might also like