B737 BRIEFINGS

OVERWEIGHT LANDING

There is no procedure / Check-List in the Boeing QRH.

Boeing does not recommend overweight autolands.

However, overweight landings may be safely accomplished by using normal landing procedures
and techniques.
The Aircraft Maintenance Manual (AMM) requires a maintenance inspection after any overweight
landing.
There are no adverse handling characteristics associated with overweight landings.
An overweight landing is generally recommended under the following conditions:
- A malfunction that seriously affects the airworthiness of the aircraft.
- A condition where an expeditious landing would reduce the exposure to a degrading level of
safety.
- One engine inoperative (although a one engine out condition affects the aircraft performance
and handling characteristics a landing must be considered in order to reduce the exposure to
additional problems with the remaining engine.
- A serious illness on board requiring immediate medical attention.
An overweight landing is generally permitted under the following conditions:
- A landing due to failures not directly affecting the airworthiness of the aircraft.
- An unplanned diversion.
An overweight landing is generally not recommended under the following conditions:
- Complete hydraulic failures affecting the braking performance.
- Tire burst / failures.
- Flight control troubles that would adversely affect the handling of the aircraft.
Autopilots on Boeing airplanes are not certified for automatic landings above maximum landing
weight. At higher than normal speeds and weights, the performance of these systems may not be
satisfactory and has not been thoroughly tested.
An automatic approach may be attempted, however the pilot should disengage the autopilot prior
to flare height and accomplish a manual landing.
Landing distance is normally less than takeoff distance for flaps 30 or 40 landings at all gross
weights. However, wet or slippery runway field length requirements should be verified from the
landing distance charts in the Perfomance Inflight chapter of the QRH. If adequate stopping
distance is available based upon approach speed, runway conditions, and runway length, the
recommended autobrake setting should be used. Remember that these distances are unfactored.
The declaration of an emergency is not required solely for an overweight landing, but the situation
that caused the overweight landing may necessitate a declaration.

Copyright 2006 - SmartCockpit.com

B737 BRIEFINGS

Page 1

B737 BRIEFINGS
Brake energy limits will not be exceeded for flaps 30 or 40 landings at all gross weights.
Analysis has determined that, when landing at high gross weights at speeds associated with nonnormal procedures requiring flaps set at 15 or less, maximum effort stops may exceed the brake
energy limits. The gross weights where this condition can occur are well above maximum landing
weights. For these non-normal landings, maximize use of the available runway for stopping.
In an emergency, should the pilot determine that an overweight autoland is the safest course of
action, the approach and landing should be closely monitored by both pilots and the following
factors considered:
- Touchdown may be beyond the normal touchdown zone; allow for additional landing distance.
- Touchdown at higher than normal sink rates may result in exceeding structural limits.
- Plan for a go-around or manual landing if autoland performance is unsatisfactory; automatic
go- arounds can be initiated until just prior to touchdown, and can be continued even if the
airplane touches down after initiation of the go-around.
In view of the increased aircraft weight, special attention shall be paid to the following items &
conditions, when considering an overweight landing :
- Pilot's physical condition : own limitation & fatigue
- Weather : IMC or VMC, temperature, crosswind, turbulence, etc.
- Runway: elevation, length, slope, obstructions (at both ends), width & surface condition.
- Aircraft: serviceability of systems, flaps, etc.

Use the longest available runway, and consider wind and slope effects.
If stopping distance is a concern, Reduce the landing weight as much as possible to minimize
stopping distance. Since the 737 does not have a fuel jettison system, weight should be reduced
at the Captain's discretion by holding at low altitude with a high drag configuration (gear down) to
achieve maximum fuel burn-off (up to 8,600 pounds, 3,900 kilograms per hour). Conditions
permitting, consider to switch ON the APU to increase fuel burn-off.
In the holding and approach patterns, maneuvers should be flown at the normal maneuver
speeds.
During flap extension, airspeed can be reduced by as much as 20 knots below normal maneuver
speeds before extending to the next flap position. These lower speeds result in larger margins to
the flap placards, while still providing normal bank angle maneuvering capability, but do not allow
for a 15 overshoot margin in all cases.
Observe flap placard speeds during flap extension and on final approach.
Fly the airplane onto the runway at the normal touchdown point.
Fly a normal profile & ensure that a higher than normal rate of descent does not develop.

Copyright 2006 - SmartCockpit.com

B737 BRIEFINGS

Page 2

B737 BRIEFINGS

If a long landing is likely to occur, go-around.

placard speed.
The pitch attitude will be about 2 or 3 higher than for Flaps 30 & care must be taken not to flare
too much and allow a float to develop.
Wind correction may be limited by the flap placards and load relief system.
After touchdown, verify speedbrake lever UP and immediately apply maximum reverse thrust
using all of the available runway for stopping to minimize brake temperatures.
After landing, consult QRH, Performance Inflight, Recommended Brake Cooling Schedule
After an overweight landing, Company Maintenance staff must be advised & appropriate
maintenance checks carried out before further flight. (see Maintenance Manual)

Where possible avoid landing in tailwinds, on runways with negative slope, or on runways with
less than normal braking conditions.
Do not carry excess airspeed on final. This is especially important when landing during an engine
inoperative or other non-normal condition. At weights above the maximum landing weight, the final
approach maximum wind correction may be limited by the flap placards and load relief system.
Do not hold the airplane off waiting for a smooth landing. Fly the airplane onto the runway at the
normal touchdown point. If a long landing is likely to occur: GO-AROUND!
Do not to flare too much and allow a float to develop.
Avoid any overweight landing on a flat tire.
Do not attempt to make an early runway turnoff after landing.

Copyright 2006 - SmartCockpit.com

B737 BRIEFINGS

Page 3