Scribd
Upload
12 views

CMPE 418: Assignment 1: Some Companies To Start With

CMPE 418: Assignment 1 is due on September 22nd. Students must write a short paper about one Automatic Test Equipment (ATE), including its architecture, test capabilities, equipment, ranges, speed, and other specifications. The paper should be 4+ pages and written formally as a technical paper. Students should pick different ATE systems to report on to avoid overlap between papers. Suggested companies to research include Teradyne, Credence, Agilent, Advantest, Yokogawa Electric Corp., Teseda, and Inovys.

Uploaded by

erdvk
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
12 views

CMPE 418: Assignment 1: Some Companies To Start With

CMPE 418: Assignment 1 is due on September 22nd. Students must write a short paper about one Automatic Test Equipment (ATE), including its architecture, test capabilities, equipment, ranges, speed, and other specifications. The paper should be 4+ pages and written formally as a technical paper. Students should pick different ATE systems to report on to avoid overlap between papers. Suggested companies to research include Teradyne, Credence, Agilent, Advantest, Yokogawa Electric Corp., Teseda, and Inovys.

Uploaded by

erdvk
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CMPE 418: Assignment 1

Due: Sept. 22nd in class


We covered details about one ATE in class. Due to time limitations we cannot survey more ATE
equipment. Your assignment is to find literature about one ATE and write a short paper on that
ATE. There are other testers that are low-speed DFT testers. You can pick those for this report if
you like. The type of details you should include are architecture, test capabilities, equipment,
ranges, speed, other important electrical specifications, etc. You are not marketing the tester for
that company, so dont make your paper like a marketing brochure. We are more interested in
knowing the capabilities of ATE currently being deployed. The paper should be formally written
as a technical paper. You can visit my or other faculty websites to look at formats of such papers.
The paper should be of appropriate size (about 4+ pages + figures etc.). There is no minimum or
maximum page limitation but use your judgement to decide how short or long it needs to be.
There are a lot of companies that make, lots of different testers so I am expecting very little overlap between your papers. You can mutually discuss the system you are picking so that there is no
overlap.
Some Companies to start with:
Teradyne
Credence (much more open documentation)
Agilent (again much more open documentation)
Advantest
Yokogawa Electric Corp.
Teseda (low speed DFT Testers)
Inovys (low speed DFT testers)

You might also like