Scribd
Upload
2K views1 page

Wiring Harness PSI Conversion

Swap Parts, Conversion Kits and Wiring Harnesses for all types of conversions can be found at http://www.psiconversion.com/

Uploaded by

Jacob Hernandez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views1 page

Wiring Harness PSI Conversion

Swap Parts, Conversion Kits and Wiring Harnesses for all types of conversions can be found at http://www.psiconversion.com/

Uploaded by

Jacob Hernandez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

'06 - '07 24X GEN IV LS2 W/ 4L60E

STANDALONE WIRING
HARNESS (DBW)
APPLICATION: 2006 - 2007 24X LS2 CORVETTE, GTO,
TRAILBLAZER
SS,dolore
SSR WITH
DRIVE
WIREeu
THROTTLE
possim assum
arum lorem
sit. Vel
illumBYdolore
feugiat WITH
4L60E OR 4L80E TRANSMISSIONS
nulla facilisis
at vero eros et accumsan et iusto odio dignissim.
PARTS INCLUDED: Complete engine and transmission wiring
harness, Instructions

These harnesses are designed for 24X Gen IV applications above. The factory E40 Controller which came
on these engines was only used for 2 years and as a result, tuners have limited experience with these
controllers. PSI, instead, uses the 1997 - 2003 Corvette PCM, TAC Module and Pedal. These items will
allow for proper function and tuning of your LS2 Engine.
These harnesses include the correct EV6 injector connectors and provisions for low mount knock sensors
and front mounted cam sensor. An alternative to drive by wire is PSI LS2 Drive By Cable Harness, P/N
HAR-1058.
They are completely plug and play with four wire hookup (switched power, constant power and ground
connections required). Harnesses are designed with a sliding grommet seal and 4 - 5 feet of length from
the rear of the cylinder head to the PCM mounting position under the vehicle dashboard. A sliding
grommet seal allows for professional, leak proof installation.
Harnesses are professionally constructed from Brand New GM Delphi Connectors and TXL (Polyethylene
Cross Linked) High Temperature Wire to GM Specifications. All harnesses are 100% Quality Inspected
prior to shipping. Note that harnesses are for non-emissions equipped vehicles and do not include air
pump or EGR provisions. All harnesses require PCM VATs removal, available through PSI. Please contact
PSI for more information.
ADDITIONAL ITEMS REQUIRED: RED/BLUE PCM (SERVICE NUMBER 411 OR 896), PSI P/N PCM-1003

ORDER ONLINE
http://www.psiconversion.com

You might also like