Scribd
Upload
75 views6 pages

How To Use Linear Pattern

The document provides instructions for creating a linear pattern in a 3D modeling program. It involves sketching a 3x3 inch rectangle and extruding it, then sketching and extruding a circular cut. A linear pattern is used to replicate the circular cut along the long and short edges of the rectangle with 1 inch spacing, creating a grid pattern of 9 total cuts.

Uploaded by

friedforever
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
75 views6 pages

How To Use Linear Pattern

The document provides instructions for creating a linear pattern in a 3D modeling program. It involves sketching a 3x3 inch rectangle and extruding it, then sketching and extruding a circular cut. A linear pattern is used to replicate the circular cut along the long and short edges of the rectangle with 1 inch spacing, creating a grid pattern of 9 total cuts.

Uploaded by

friedforever
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

How to use Linear Pattern

In this tutorial, you will create this part.

1.Click New.

Click Part,

OK.

2.Click Front Plane

and click on Sketch.

3.Click Rectangle,
sketch rectangular. Click Smart Dimension,
dimension rectangular 3in x 3in.

4.Click Feature>Extruded Boss/Base,

set D1 to 1.0in and OK.


5. Click on front face and select Normal to.

6.Click front face and Insert Sketch.

7.Click Circle,

sketch circle at one edge.

8.Click Smart Dimension,

dimension circle as below sketch.

9.Click Features>Extruded Cut,

set Direction 1, Through All and OK.

10.Click Linear Pattern,

click left edge,

on Direction 1 set spacing D1 to 1.0in and Instances # to 3.

11.Click bottom edge,

on Direction 2 set spacing D2 to 1.0in and Instances # to 3.

12.Click inside white box Features to Pattern.

Open up part tree, select Extrude 2

and OK.
13.Youre done!

You might also like