0% found this document useful (0 votes)
104 views2 pages

Solar Charger Circuit

This circuit uses a 12 volt solar panel and voltage regulator IC LM317 to charge a 6 volt 4.5 Ah lead-acid or Ni-Cd battery. The LM317 regulates the voltage and current from the solar panel to safely charge the battery. A resistor limits the charging current while diodes prevent overcharging and back discharge from the battery. When the battery is fully charged to over 6.8 volts, a zener diode and transistor cut off the charging circuit to protect the battery from overcharging.

Uploaded by

VishalMeena
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
104 views2 pages

Solar Charger Circuit

This circuit uses a 12 volt solar panel and voltage regulator IC LM317 to charge a 6 volt 4.5 Ah lead-acid or Ni-Cd battery. The LM317 regulates the voltage and current from the solar panel to safely charge the battery. A resistor limits the charging current while diodes prevent overcharging and back discharge from the battery. When the battery is fully charged to over 6.8 volts, a zener diode and transistor cut off the charging circuit to protect the battery from overcharging.

Uploaded by

VishalMeena
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

SOLAR CHARGER CIRCUIT

Posted by P. Marian in Power supply, Solar | 292 comments


More projects with: LM317 Solar cells Solar charger

Add to favorites
Here is a solar charger circuit that is used to charge Lead Acid or Ni-Cd batteries
using the solar energy power. The circuit harvests solar energy to charge a 6 volt 4.5
Ah rechargeable battery for various applications. The charger has Voltage and
Current regulation and Over voltage cut off facilities.

Solar Charger Circuit Diagram

The circuit uses a 12 volt solar panel and a variable voltage regulator IC LM 317. The
solar panel consists of solar cells each rated at 1.2 volts. 12 volt DC is available from
the panel to charge the battery. Charging current passes through D1 to the voltage
regulator IC LM 317. By adjusting its Adjust pin, output voltage and current can be
regulated.
VR is placed between the adjust pin and ground to provide an output voltage of 9
volts to the battery. Resistor R3 Restrict the charging current and diode D2 prevents
discharge of current from the battery. Transistor T1 and Zener diode ZD act as a cut
off switch when the battery is full. Normally T1 is off and battery gets charging
current.
When the terminal voltage of the battery rises above 6.8 volts, Zener conducts and
provides base current to T1. It then turns on grounding the output of LM 317 to stop
charging.

You might also like