DUAL BAND FM TRANSCEVER
S-14325XZ-C1
Mar. 2007
INTRODUCTION
CAUTION
This service manual describes the latest service information
for the IC-2820H DUAL BAND FM TRANSCEVER at the
time of publication.
NEVER connect the transceiver to an AC outlet or to a DC
power supply that uses more than 15 V. This will ruin the
transceiver.
MODEL
VERSION
USA-01
AUS-01
KOR-01
TPE-01
EXP-01
IC-2820H
DO NOT expose the transceiver to rain, snow or any liquids.
DO NOT reverse the polarities of the power supply when
connecting the transceiver.
DO NOT apply an RF signal of more than 20 dBm (100 mW)
to the antenna connector (J1). This could damage the
transceivers front end.
To upgrade quality, any electrical or mechanical parts and
internal circuits are subject to change without notice or
obligation.
ORDERING PARTS
REPAIR NOTES
Be sure to include the following four points when ordering
replacement parts:
1. Make sure a problem is internal before disassembling
the transceiver.
2. DO NOT open the transceiver until the transceiver is
disconnected from its power source.
3. DO NOT force any of the variable components. Turn
them slowly and smoothly.
4. DO NOT short any circuits or electronic parts. An
insulated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the
transceiver is defective.
6. DO NOT transmit power into a signal generator or a
sweep generator.
7. ALWAYS connect a 50 dB to 60 dB attenuator between
the transceiver and a Modulation Analyzer or spectrum
analyzer when using such test equipment.
8. READ the instructions of test equipment thoroughly
before connecting equipment to the transceiver.
1. 10-digit order numbers
2. Component part number and name
3. Equipment model name and unit name
4. Quantity required
<SAMPLE ORDER>
1110003491 S.IC
TA31136FNG IC-2820H
8820001210 Screw 2438 screw
IC-2820H
MAIN UNIT
5 pieces
Top cover
10 pieces
Addresses are provided on the inside back cover for your
convenience.
Icom, Icom Inc. and
logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United
Kingdom, Germany, France, Spain, Russia and/or other countries.
CONTENTS
SECTION
SPECIFICATIONS
SECTION
INSIDE VIEWS
SECTION
DISASSEMBLY INSTRUCTIONS
SECTION
CIRCUIT DESCRIPITON
SECTION
4-1
RECEIVER CIRCUITS ............................................................................................................... 4-1
4-2
TRANSMITTER CIRCUITS ....................................................................................................... 4-4
4-3
FREQUENCY SYNTHESIZER .................................................................................................. 4-6
4-4
POWER SUPPLY CIRCUITS ..................................................................................................... 4-8
4-5
PORT ALLOCATIONS ............................................................................................................... 4-9
ADJUSTMENT PROCEDURES
5-1
PREPARATION .......................................................................................................................... 5-1
5-2
FREQUENCY ADJUSTMENT ................................................................................................... 5-2
5-3
TRANSMIT ADJUSTMENT ....................................................................................................... 5-3
5-4
RECEIVE ADJUSTMENT .......................................................................................................... 5-4
SECTION
PARTS LIST
SECTION
MECHANICAL PARTS
SECTION
BOARD LAYOUTS
SECTION
BLOCK DIAGRAM
SECTION
10 VOLTAGE DIAGRAM
SECTION
11 HM-133
SECTION
12 UT-123 (Optional product)
SECTION 1
SPECIFICATIONS
M '%.%2!,
s &REQUENCY COVERAGE
UNIT -(Z
6ERSION
,EFT "AND
53!
'ENERAL
2X n
4X n n
2IGHT "AND
2X n
n
n
4X n n
!USTRALIA
4X2X n n
4AIWAN
4X2X n n
+OREA
4X2X n n
'UARANTEED n -(Z RANGE ONLY
'UARANTEED n -(Z RANGE FOR THE 53!
n -(Z FOR THE 'ENERAL VERSION
.OT GUARANTEED
TO AND
TO -(Z RANGES ARE INHIBITED FOR 53! VERSION AND NOT GUARANTEED
s 4YPE OF EMISSION
&- !- 2ECEIVE ONLY
$6 OPTIONAL 54
IS REQUIRED
s .UMBER OF MEMORY CHANNELS
INCL SCAN EDGES AND CALLS
s &REQUENCY RESOLUTION
K(Z
n# TO # &