0% found this document useful (0 votes)
55 views2 pages

Enhanching Solar Efficency by Solar Focusing Prependicular Assimilattion of The Solar Light

This document describes a solar panel mount with a solar tracking controller that aims to maximize the solar panel's power output by keeping it aligned with the sun. It estimates that utilizing a tracking system can increase a solar panel's yield by 30-60% compared to a stationary array. The tracking system uses a microcontroller to adjust the panel's position to ensure the incident light falls on the panel at a 90 degree angle for maximum light absorption. This allows for more photons to be captured, increasing the current and overall energy that can be harnessed from the solar panel.

Uploaded by

Juan Jackson
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
55 views2 pages

Enhanching Solar Efficency by Solar Focusing Prependicular Assimilattion of The Solar Light

This document describes a solar panel mount with a solar tracking controller that aims to maximize the solar panel's power output by keeping it aligned with the sun. It estimates that utilizing a tracking system can increase a solar panel's yield by 30-60% compared to a stationary array. The tracking system uses a microcontroller to adjust the panel's position to ensure the incident light falls on the panel at a 90 degree angle for maximum light absorption. This allows for more photons to be captured, increasing the current and overall energy that can be harnessed from the solar panel.

Uploaded by

Juan Jackson
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

ENHANCHING SOLAR EFFICENCY BY SOLAR

FOCUSING PREPENDICULAR ASSIMILATTION OF


THE SOLAR LIGHT

Chandan Guleria(2013PGME002),Abhishek Kapil Sharma(2013PGME001)


Pankaj singh(2013PGME003),Aman Sharma(2011UGME012)

Bahra University,V.P.O. Kiarighat, Tehsil Kandaghat,District. Solan (H.P.) - 173215, Waknaghat,


Himachal Pradesh 173234 (MAY 2014)

Abstract

The recent decades have seen the increase in the demand for reliable and clean form of electricity
derived for renewable energy resources, one such example is Solar Panel. The challenge remains
to maximize the capture of the rays from the sun for conversion in to electricity. This paper
presents fabrication and installation of solar panel mount with a solar tracking controller. In
order to maximize power output from solar panel one is to keep panel aligned to the sun, as such
a means of tracking the sun is required, this is definitely a more cost effective solution than
purchasing additional solar panels.it has been estimated that the yield from solar panels can be
increased by 30-60 % by utilizing a tracking system and using inverted pyramid like
structure(PERC (passivated emitter, rear cell) type is a good candidate for commercialization
While the PERL (passivated emitter, rear locally di_used cell) instead of stationary array. This
paper a prototype for Microcontroller based multi-function solar tracking system is described.

Introduction:
The microcontroller in the solar panels are used to track the solar light with the passing and the
shades in the best possible angle that it always accur at 90 degree.the microcantoller made the
incidenc light to fall on the solar panel in the angle is 90 degree all the times. This make the
incident light to get the maximum wavelength and so maximum photon that can be captured and
the maximum of the light has been captured and make which makes the photons to get captured

in the system and so all of the sudden maximum energy can be harnessed out of the photon and
more current is being produced and then the more storage can be used.
The pn junction at open circuit.the left and right side consist of the same semiconductor
material(i.e. same band gap),just doped differentely.carriers within the depletion zone separate
(e~ s flow left,nad h+ ,s flow lright.the voltage V

You might also like