Scribd
Upload
408 views12 pages

Hypermesh Analysis For UDL

The document outlines the steps taken to analyze bending with a uniformly distributed load (UDL) in a beam using Hypermesh and Radioss software. It describes selecting materials and properties, defining the beam geometry with nodes and bars, applying constraints and UDL forces, running the analysis in Radioss, and reviewing displacement and stress results in Hyperview, finding the maximum displacement of 72mm and stresses of -657.5 MPa and 657.5 MPa at specific points.

Uploaded by

kapilrajeev
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
408 views12 pages

Hypermesh Analysis For UDL

The document outlines the steps taken to analyze bending with a uniformly distributed load (UDL) in a beam using Hypermesh and Radioss software. It describes selecting materials and properties, defining the beam geometry with nodes and bars, applying constraints and UDL forces, running the analysis in Radioss, and reviewing displacement and stress results in Hyperview, finding the maximum displacement of 72mm and stresses of -657.5 MPa and 657.5 MPa at specific points.

Uploaded by

kapilrajeev
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 12

Bending with UDL

Name: Kapil Agrawal


Student id: 2014pde5032
SelecttheMaterial for the Beam
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Select Hyper Beam to define crossection of the Beam
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Select Property for the Beam
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Define Component:

Create Nodes for definingLength of the beam:
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Create Bar by selecting all the nodes :
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Define Load Collector and Constraints:
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Define Load Collector and Force:
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Define Load Steps:
Save the Model :
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Go to Radioss and save as the model to .fem extension:
Click Radioss to Run the analysis:
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Open Two Window option to run Hyperview along with Hypermesh:
Load the file with extension .h3d:
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Select Displacement as result type: Maximum value of displacement is: 72mm
Select element stress as result type:
Maximum Stress at C is -657.5 Mpa
Bending with UDL
Name: Kapil Agrawal
Student id: 2014pde5032
Stress at D will be 0
Max Stress at point E will be657.5MPa

You might also like