Scribd
Upload
809 views

Circuit Debugging Round1

The document contains 15 multiple choice questions related to circuits, electronics, and microprocessors. It tests knowledge on topics like Ohm's law, capacitance, Boolean logic, memory, time constants, bandwidth, LED current, MOSFET operation, oscillators, PN junction voltage, counters, duty cycle, 8085 registers, address buses, and data sheet specifications.

Uploaded by

Saravanan Jagan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
809 views

Circuit Debugging Round1

The document contains 15 multiple choice questions related to circuits, electronics, and microprocessors. It tests knowledge on topics like Ohm's law, capacitance, Boolean logic, memory, time constants, bandwidth, LED current, MOSFET operation, oscillators, PN junction voltage, counters, duty cycle, 8085 registers, address buses, and data sheet specifications.

Uploaded by

Saravanan Jagan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

1 | P a g e

Circuit Debugging Round-I



Max.Time:15 minutes No of Questions: 15


1. Find the value of R if the current flowing through R is 4 Ampere.



a) 3.5 b) 2.5 c) 1 d) 5

2. Find the equivalent capacitance across ab.



a) 0.2F b)0.1F c)0.5F d)0F


3. For the switch in the circuit, taking 0 as open and 1 as closed the expression of Y
is



a)A+(B+C)D b)A+BC+D c)A(BC+D) d)None of this


4. If the memory chip size is 256x1 bits, then number of chips required to make up
1KB of memory is

a)32 b)24 c)12 d)1000





2 | P a g e



5. The time constant in the given network is

a)CR b)2CR c)CR/4 d)CR/2


6. What is the bandwidth of the circuit?



a)31.8 Hz b)32.3 Hz c)142 Hz d)7.2 kHz


7. What is the current through the LED?


a)0 mA b)23 mA c)18 mA d)13 mA

8.The depletion-mode MOSFET

a)can operate with only positive gate voltage
b)can operate with only negative gate voltages
c)cannot operate in the ohmic region
d)can operate with positive as well as negative gate voltages




3 | P a g e






9. Initially, the closed-loop gain (Acl) of a Wien-bridge oscillator should be

a)Acl < 3 b)Acl > 3 c)0 d)Acl approximately equals to 1




10. What is the voltage across R1 if the P-N junction is made of silicon?









a)12 V b)11.7 V c)11.3 V d)0 V


11. How many flip-flops are required to produce a divide-by-128 counter device?
a)1 b)4 c)6 d)7





12. If a diode is connected across resistor RB (positive end up) in the given figure,
what is the new duty cycle of the output waveform?


a)56% b)44% c)21.6% d)17.4%



4 | P a g e





13. The register in the 8085A that is used to keep track of the memory address of
the next op-code to be run in the program is the:
a)stack pointer b)program counter c)instruction pointer d)accumulator



14.The 8-bit address bus allows access to an address range of:

a)0000 to FFFFH b)000 to FFFH c)00 to FFH d)0 to FH




15.Which of the following will not normally be found on a data sheet?

a)Minimum HIGH level output voltage b)Maximum LOW level output voltage

c)Minimum LOW level output voltage d)Maximum HIGH level input current

You might also like