Scribd
Upload
36 views3 pages

Engineering Drawing & Graphics Lab-II (ME 2021) Semester Fall 2013 Sections: S1, S2, S3 Lab Activity No. 1

This document provides instructions for the first lab activity in an Engineering Drawing and Graphics course at Mohammad Ali Jinnah University. Students are asked to write out the absolute and relative rectangular coordinates for points on several profiles, and then use those coordinates to draw the profiles in AutoCAD. They are also instructed to draw another profile using absolute, relative rectangular, and relative polar coordinate systems without including any dimensions.

Uploaded by

Mohammad Faraz Akhter
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
36 views3 pages

Engineering Drawing & Graphics Lab-II (ME 2021) Semester Fall 2013 Sections: S1, S2, S3 Lab Activity No. 1

This document provides instructions for the first lab activity in an Engineering Drawing and Graphics course at Mohammad Ali Jinnah University. Students are asked to write out the absolute and relative rectangular coordinates for points on several profiles, and then use those coordinates to draw the profiles in AutoCAD. They are also instructed to draw another profile using absolute, relative rectangular, and relative polar coordinate systems without including any dimensions.

Uploaded by

Mohammad Faraz Akhter
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Department of Mechanical

Engineering


1/3

Mohammad Ali Jinnah University
Islamabad Campus

Engineering Drawing & Graphics Lab-I I (ME 2021)
Semester: Fall 2013
Sections: S1, S2, S3
Lab Activity No. 1

1. Write coordinates of all points of the profiles shown below, in both absolute and relative
rectangular coordinate system. Then use these coordinates to draw these figures in
AutoCAD.
The distance between the dotted lines is 1 unit.


Absolute Relative
@
Department of Mechanical
Engineering


2/3

Mohammad Ali Jinnah University
Islamabad Campus




Absolute Relative
Department of Mechanical
Engineering


3/3

Mohammad Ali Jinnah University
Islamabad Campus
2. Draw the profile shown below by specifying points using the absolute, relative
rectangular and relative polar coordinate systems. Do not dimension the profile. They
are given for reference only.

You might also like