0% found this document useful (0 votes)
26 views27 pages

Diff Amps

The document discusses different modes of operation and characteristics of differential amplifiers. It covers BJT and MOSFET differential pairs, current mirrors, analysis of common-mode and differential-mode signals, equivalent circuit models, and types of active and passive loads that can be used. It also lists references used for more information on electronics circuits.

Uploaded by

Vinay Goddemme
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
26 views27 pages

Diff Amps

The document discusses different modes of operation and characteristics of differential amplifiers. It covers BJT and MOSFET differential pairs, current mirrors, analysis of common-mode and differential-mode signals, equivalent circuit models, and types of active and passive loads that can be used. It also lists references used for more information on electronics circuits.

Uploaded by

Vinay Goddemme
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 27

0

EE-4232
Differential Amplifiers
1
Different modes of operation of the differential pair: The differential pair with a common-
mode input signal v
CM
.
2
Different modes of operation of the differential pair: The differential pair with a large
differential input signal.
3
Different modes of operation of the differential pair: The differential pair with a large input
signal of polarity opposite to that in (b).
4
Different modes of operation of the differential pair: The differential pair with a small
differential input signal v
i
.
5
Transfer characteristics of the BJT differential pair of previous figure assuming 1.
6
The current and voltages in the differential amplifier when a small
difference signal v
d
is applied.
7
A simple technique for determining the signal currents in a differential amplifier
excited by a differential voltage signal v
d
; dc quantities are not shown.
8
A differential amplifier with emitter existence. Only signal quantities are shown (on color).
9
Equivalence of the differential amplifier (a) to the two common-emitter amplifiers in
(b). This equivalence applies only for differential input signals. Either of the two
common-emitter amplifiers in (b) can be used to evaluate the differential gain, input
differential resistance, frequency response, and so on, of the differential amplifier.
10
(a) The differential amplifier fed by a common-mode voltage signal. (b) Equivalent
half-circuits for the common-mode calculations.
11
Analysis of the current mirror taking into account the finite of the BJTs.
12
Generation of a number of cross currents.
13
A current mirror with base-current compensation.
14
The Wilson current mirror.
15
The Widlar current source.
16
17
A differential amplifier with an active load.
18
Small-signal model of the differential amplifier.
19
The MOSFET differential pair.
20
Normalized plots of the currents in a MOSFET differential pair. Note that V
GS
is the
gate-to-source voltage when the drain current is equal to the dc bias current (I/2).
21
MOS current mirrors: basic
22
MOS current mirrors: cascode
23
MOS current mirrors: Wilson
24
MOS current mirrors: modified Wilson
25
A multistage amplifier circuit.
26
References
Electronics by A. Hambley
Microelectronics Circuits by Sedra & Smith
Other books on Electronics

You might also like