Scribd Logo
Upload

Welcome to Scribd!

  • 126 views

    ELG 3336 Pre Lab 1

    Uploaded by

    Joshua Harris
    This pre-lab document describes using Multisim software to simulate an experiment with an inverting operational amplifier circuit. The circuit includes two resistors and one op-amp, with a function generator connected and an oscilloscope used to measure voltage and current. Screenshots show the oscilloscope readings across the resistor at different frequencies and voltages, and the voltages measured follow Ohm's law calculations.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd

    ELG 3336 Pre Lab 1

    Uploaded by

    Joshua Harris
    126 views3 pages
    This pre-lab document describes using Multisim software to simulate an experiment with an inverting operational amplifier circuit. The circuit includes two resistors and one op-amp, with a function generator connected and an oscilloscope used to measure voltage and current. Screenshots show the oscilloscope readings across the resistor at different frequencies and voltages, and the voltages measured follow Ohm's law calculations.

    Original Title

    ELG 3336 Pre lab 1

    Copyright

    © © All Rights Reserved

    Available Formats

    DOCX, PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    This pre-lab document describes using Multisim software to simulate an experiment with an inverting operational amplifier circuit. The circuit includes two resistors and one op-amp, with a function generator connected and an oscilloscope used to measure voltage and current. Screenshots show the oscilloscope readings across the resistor at different frequencies and voltages, and the voltages measured follow Ohm's law calculations.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    126 views3 pages

    ELG 3336 Pre Lab 1

    Uploaded by

    Joshua Harris
    This pre-lab document describes using Multisim software to simulate an experiment with an inverting operational amplifier circuit. The circuit includes two resistors and one op-amp, with a function generator connected and an oscilloscope used to measure voltage and current. Screenshots show the oscilloscope readings across the resistor at different frequencies and voltages, and the voltages measured follow Ohm's law calculations.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    of 3

    ELG 3336

    PRE LABORATORY 1
    Inverting Operational Amplifier




    Presented to
    Mahmud Hasan





    By
    Justin Lefebvre 6832573






    15 September 2014
    University of Ottawa

    The objective of this pre lab is to use the software multisim to reproduce the circuits and data
    that will be seen in the actual experiment. The following circuit was produced in the software
    that includes two resistors and one Op Amp. The function generator which is branched in circuit
    while the Oscilloscope in paralleled to measure the current and voltage thought each element.


    Circuit


    The following images are what the oscilloscope read from the resistor followed by the capacitor.
    What was found using ohms law and the data was running through the resistor was 7 mV and 1.4 mV at
    the varying frequencys and pin voltages.









    Oscillator scope reading at 100 Hz and 15 V

    Oscillator scope reading at 100 KHz and 15 V

    You might also like