Scribd
Upload
261 views1 page

Homework #8 KL2103 Engineering Mechanics, Class 02: Problem 1

This document contains homework problems for an engineering mechanics class. Problem 1 asks students to draw influence lines for the vertical reactions at supports B, D, and F, as well as for the bending moment at point E and shear forces on either side of support D. Problem 2 asks students to use the influence lines from Problem 1 to calculate reactions and bending moment for a given structure. Problem 3 asks students to determine maximum values for reactions, bending moments, and shear forces using influence lines under given dead and live loads. Problem 4 repeats Problem 3 but replaces the live loads with specific wheel loads.

Uploaded by

Andy Bayu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
261 views1 page

Homework #8 KL2103 Engineering Mechanics, Class 02: Problem 1

This document contains homework problems for an engineering mechanics class. Problem 1 asks students to draw influence lines for the vertical reactions at supports B, D, and F, as well as for the bending moment at point E and shear forces on either side of support D. Problem 2 asks students to use the influence lines from Problem 1 to calculate reactions and bending moment for a given structure. Problem 3 asks students to determine maximum values for reactions, bending moments, and shear forces using influence lines under given dead and live loads. Problem 4 repeats Problem 3 but replaces the live loads with specific wheel loads.

Uploaded by

Andy Bayu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Homework #8 Semester I 2012/2013

KL2103 Engineering Mechanics, Class 02


Due: Thursday, November 29, 2012

Problem 1
Draw the influence lines of:
vertical reactions at supports B, D, and F
bending moment at E (the middle of span DF)
shear force immediately to the left and right of support D
as a unit load moves from A to G.







Problem 2
Use the influence lines from Problem 1 to calculate all reactions and bending moment at E for the
structure shown below.










Problem 3
The beam structure in Problem 1 will be designed to receive:
Dead load: uniform load of 3 kips/ft, applied on the entire beam, and
Live loads: uniform load of 6 kips/ft and a concentrated load of 25 kips.

Use the influence lines to determine:
the maximum value of each vertical reactions
the maximum value of positive bending moment at E
the maximum value of negative bending moment at E
the maximum value of shear force immediately to the left of support D
the maximum value of shear force immediately to the right of support D


Problem 4
Repeat Problem 3, but replace the live loads with the wheel loads shown below:









B
10 ft
C
D
12 ft
E
12 ft
A G F
10 ft 10 ft 6 ft
B
10 ft
C
D
12 ft
E
12 ft
A G F
10 ft 10 ft 6 ft
5 kips/ft
3 kips/ft
10 kips
20 kips
12 ft
24 kips
6 ft
24 kips
6 kips

You might also like