Scribd
Upload
29 views

Guidelines For Writing Lab Reports: I. Opening Paragraph

The document provides guidelines for writing lab reports, including sections for an opening paragraph describing the experiment, procedures, data presented in a table with units, labeled sketches and graphs, analysis with equations and sample calculations, and conclusions addressing if objectives were met and things learned. Following these guidelines will help ensure lab reports are typed, clearly presented, and address critical elements of the experiment.

Uploaded by

CuongNgo
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
29 views

Guidelines For Writing Lab Reports: I. Opening Paragraph

The document provides guidelines for writing lab reports, including sections for an opening paragraph describing the experiment, procedures, data presented in a table with units, labeled sketches and graphs, analysis with equations and sample calculations, and conclusions addressing if objectives were met and things learned. Following these guidelines will help ensure lab reports are typed, clearly presented, and address critical elements of the experiment.

Uploaded by

CuongNgo
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Guidelines for Writing Lab Reports

All lab reports that you turn in must be typed and follow these general guidelines:

I. Opening Paragraph
It should be a short statement or description of what you are going to do in the
experiment.

II. Procedures and Descriptions
Describe any procedure that is not spelled out in the lab manual. Include a schematic to
show wire connections, distances, etc

III. The Data
List your original data in a table. It is critical that you write down the units for
everything.

IV. Sketches and Graphs
Clearly label all axes on your graphs. If two or more curves or lines are included in the
same graph, make sure you indicate which curve is which with some sort of legend. Graphs are
usually constructed with the independent variable (what you are changing) on the horizontal axis,
and the dependent variable (the affected quantity) on the vertical axis.

V. Analysis
This is one of the most important aspects of the lab report. Always indicate which
equations you are using and write them down. Always show a sample calculation. When asked to
compare two quantities, such as a theoretical value to an experimental value, be sure to calculate
the percentage error.

VI. Conclusions
Use it to show that you understood what you did. Answer these general questions:
(a) Did you accomplish what you set out to do? If you did, briefly back up this accomplishment
with your measured quantities and graphs.
(b) What specific problems did you encounter and how did you solve them?
Finally, state some of the things you have learned in by doing the experiment.

Be Neat and Clear in your writing. It counts!!!

You might also like