Scribd
Upload
2K views1 page

Pls-Tower Step

This document provides steps to model a tower in PLS-Tower: create a joint, symmetrically duplicate the joint, create a member connected to the joint, symmetrically duplicate the member, apply loads through an LCA file, and run the model.

Uploaded by

Ahmed Sayyid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
2K views1 page

Pls-Tower Step

This document provides steps to model a tower in PLS-Tower: create a joint, symmetrically duplicate the joint, create a member connected to the joint, symmetrically duplicate the member, apply loads through an LCA file, and run the model.

Uploaded by

Ahmed Sayyid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

PLS-Tower Steps

1- Create joint
2- Symmetry the joint
3- Create member
4- Symmetry the member
5- Apply Loads through LCA file
6- Run model

You might also like