Scribd
Upload
57 views1 page

Lala

The document describes a quiz question about using a Schering Bridge circuit to measure the resistance and capacitance of a concentric cable. The circuit uses a 1V rms power voltage at 50 Hz frequency. Readings are taken at the balance condition and students are asked to: 1) derive expressions for the series capacitance and resistance of the cable, 2) calculate the series capacitance value and equivalent parallel resistance, and 3) discuss the effect of high capacitance and resistance on the tangent value. The quiz is worth 10 marks.

Uploaded by

Sebastian Langkah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
57 views1 page

Lala

The document describes a quiz question about using a Schering Bridge circuit to measure the resistance and capacitance of a concentric cable. The circuit uses a 1V rms power voltage at 50 Hz frequency. Readings are taken at the balance condition and students are asked to: 1) derive expressions for the series capacitance and resistance of the cable, 2) calculate the series capacitance value and equivalent parallel resistance, and 3) discuss the effect of high capacitance and resistance on the tangent value. The quiz is worth 10 marks.

Uploaded by

Sebastian Langkah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Quiz

a) The Schering Bridge shown in figure 1 is employed to measure the resistance and
capacitance of concentric cable. The series Cx and Rx branch of the bridge represents the
cable. The power voltage to the bridge is 1!"rms at # $% fre&uency.
The readings obtained from the experiment at balance condition are'
i) (erive expression for the series capacitance Cx and series resistance Rx) of the specimen
state an assumptions you made during the analysis.
ii) Calculate the value of Cx) and e&uivalent parallel resistance corresponding to Rx.
iii) (iscuss the effect of high Cx and Rx to tan*
+1, mar!s)

You might also like